12-04-2006
There shouldn't be any problems for Suse to run on AMD, i had this configuration few months ago, even on 64bit, and it was quite good indeed. I suppose the error is result of incorrect installation.
3 More Discussions You Might Find Interesting
1. UNIX for Advanced & Expert Users
Dear All Experts,
Would like to know the maturity/ stability of Redhat Linux AS 3.0 and Solaris.
My organization need to setup cluster solution. We are well-versed with Veritas Cluster on Solaris.
We are thinking of waiting for certification support of the various ISV like Oracle, Veritas... (3 Replies)
Discussion started by: izy100
3 Replies
2. Linux Benchmarks
CPU/Speed: AMD Phenom(tm) 9950 Quad-Core Processor
Ram: 3.6 GB
Motherboard: Foxconn 7da-s
Bus:
Cache:
Controller:
Disk:
Load:
Kernel: Linux 2.6.26-2-amd64
Kernel ELF?:
pgms:
==============================================================
BYTE UNIX Benchmarks (Version... (0 Replies)
Discussion started by: migracho
0 Replies
3. Linux
i'm new linux ... after reboot ...... my keyboard is notworking
automatically boot ..... after few mins
Waiting for mandatory devices: eth-id-00:10:a7:08:cb:4b
12 11 9 8 7 5 4 3 1 0
eth0 interface could not be set up
failed
Setting up service network . . . . . . . . . . . . .
... (2 Replies)
Discussion started by: coolboys
2 Replies
LEARN ABOUT DEBIAN
amdtemp
AMDTEMP(4) BSD Kernel Interfaces Manual AMDTEMP(4)
NAME
amdtemp -- device driver for AMD K8, K10 and K11 on-die digital thermal sensor
SYNOPSIS
To compile this driver into the kernel, place the following line in your kernel configuration file:
device amdtemp
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
amdtemp_load="YES"
DESCRIPTION
The amdtemp driver provides support for the on-die digital thermal sensor present in AMD K8, K10 and K11 processors.
For the K8 family, the amdtemp driver reports each cores' temperature through a sysctl node in the corresponding CPU devices's sysctl tree,
named dev.amdtemp.%d.sensor{0,1}.core{0,1}. The driver also creates dev.cpu.%d.temperature displaying the maximum temperature of the two
sensors located in each CPU core.
For the K10 and K11 families, the driver creates dev.cpu.%d.temperature with the temperature of each core.
BUGS
AMD K9 is not supported because temperature reporting has been replaced by Maltese.
SEE ALSO
sysctl(8)
HISTORY
The amdtemp driver first appeared in FreeBSD 7.1.
AUTHORS
Rui Paulo <rpaulo@FreeBSD.org>
Norikatsu Shigemura <nork@FreeBSD.org>
BSD
April 8, 2008 BSD