1. IP Networking

I am trying to set an interface to 100/Full, but the command I use are getting rejected. I think it is the last argument, but I don't know how to find the correct values. I am trying to use the following script, but change hme to le . echo "Setting hme interface 1: 100mb/full-duplex..." ... (2 Replies)

2. Solaris

Hello Gurus I would like to know more about ndd commands related to ethernet(NIC) like how to set link_status, link_speed & link_mode as I know how to check these value. And I also would like to know how to make these setting permanents after reboot as I know that these setting will vanish... (5 Replies)

3. Programming

Hi, Is there any function calls available ( for using in a C program ) to get the Ethernet Link status. ? I am looking for the status available from ndd /dev/hme link_status And how about plumbing and configuring an interface using C program ? BTW, Is all this documented... (3 Replies)

4. Solaris

Hi, I would like to know whether there is any config file that i can refer to for the result of 'ndd -get /dev/tcp tcp_time_wait_interval'? When i man 'ndd', there is one statement which is -> Each driver chooses which parameters to make visible using ndd. Does it answering my question above... (3 Replies)

5. Solaris

Solaris 10 server (SunOS 5.10 Generic_137137_09) I have a services file configured in /etc in there windows clients connect to my server on port 6034-6037 when I do the following netstat | grep TestServices it pulls all the connections active for those ports so right now I have 10 clients... (3 Replies)

6. UNIX for Advanced & Expert Users

I have a T2000 server which has 4 e1000g NIC cards How do I configure each of it for 1Gbit full duplex and turnoff autonegotiation. Please assist Thanks (4 Replies)

7. Solaris

Following command was set up in startup script on Solaris 8 servers - improved network transfers of files from one server to the another (doubled transfer speed). ndd -set /dev/tcp tcp_host_param '10.140.20.10 sendspace 279600 recvspace 279600 timestamp 1' Now they are getting a new server... (15 Replies)

8. Solaris

Hello forum, I have a Solaris 9 Sun Fire v240 server and Sun Fire v440 Recently we made changes and installed a new switch which both of them are connected to it. Cisco Catalyst 3750. Now the Sun Server v240 is having problems with the network. It was supposed to run at 1000mbs speed. ndd... (10 Replies)

9. Solaris

Hi, Recently, I had to disable autoneg in one of my servers having ixgbe1 interface. While using below command I got "Permission denied" error: ndd -set /dev/ixgbe1 adv_autoneg_cap 0 On investigating further I found that adv_autoneg_cap is showing as read-only parameter. Although it is... (1 Reply)