Sponsored Content
Top Forums UNIX for Dummies Questions & Answers Failing to boot - DMVA problem Post 102398 by forbin24 on Friday 17th of March 2006 12:55:46 PM
Old 03-17-2006
Failing to boot - DMVA problem

SunOS 5.6

I have a remote test system (test T1/T3, etc) that runs SunOS 5.6. I rebooted the system for no other reason than that it had been up for over 300 days. It failed to boot completely.

I have an ok prompt and when I type boot, I see the following messages..
Boot device: /iommu/sbus/espdma@5,8400000/esp@5,8800000/sd@0,0 File and args: -r
Short read. 0x2000 chars read
Short read. 0x2000 chars read
Short read. 0x2000 chars read
Short read. 0x2000 chars read
|
Watchdog Reset

There are some diagnostic tools that pointed me to the problem:
CS4231 ASIC SelfTest Passed.
Error: DVMA failure internal loopback
expected 2 received 0
Error: DVMA failure internal loopback
expected 4 received 0
Error: DVMA failure internal loopback
expected 8 received 0
Error: DVMA failure internal loopback
expected 10 received 0
Error: DVMA failure internal loopback
expected 20 received 0
Error: DVMA failure internal loopback
expected 40 received 0
Error: DVMA failure internal loopback
expected 80 received 0
Selftest failed. Return code = 7
ok

Based on this output, I used another diag tool to check the memory map and got the following results:
Virtual : 0000.0002
Context : @ 0.01ff.f000 001f.eec1 # 0
Region : @ 0.01fe.ec00 001f.ee71
Segment : @ 0.01fe.e700 001f.ee61
Page : @ 0.01fe.e600 0000.001c Invalid
Stack Underflow

So it appears to me that the system can't find the pages it's looking for. I'm in very short supply of CPUs so will probably attempt to reload the OS/software. This is a bit of a hassle because it's a remote site.

What I'm looking for is opinions on what the most likely cause of the problem is and if there is some way to possibly fix this without a CPU replacement or OS/software reload. I've already reseated the CPU and I get the same results.

Thanks for you time!
 

10 More Discussions You Might Find Interesting

1. UNIX for Advanced & Expert Users

Boot problem

we have a problem with a server UNIX SUN OS 5.7 : we tried to reboot it and we have the following error message : "boot load failed the file just loaded does not appear to be executable " we booted the server in single user mode with the cdrom we made the mirrored disk bootable we tried... (2 Replies)
Discussion started by: farzolito
2 Replies

2. UNIX for Advanced & Expert Users

Boot Problem

Hi All. Yesterday my pc worked fine. Today when booting the sequence gets just past mounting the root filesystem - it then says ' Module dependencies up to date (no new kernel modules found).' At this point it hangs and goes no further! Does this sound familiar to anyone? I am running... (2 Replies)
Discussion started by: silvaman
2 Replies

3. Solaris

solaris boot problem boot error loading interpreter(misc/krtld)

When I installed the SOLARIS 10 OS first time, the desktop would not start up, this was because of network setup. Reinstalled worked. After a week due to some problem I had to reinstall OS, installation went fine and but when i reboot I get this error. cannot find mis/krtld boot error loading... (0 Replies)
Discussion started by: johncy_j
0 Replies

4. UNIX for Advanced & Expert Users

unix server failing to boot

i have unix 5.4 running on team server hs failing to boot. when i turn it on, it prints the following lines on the screen and just stops: module ID 01: (0011) Main power supply ok module ID 01: (0012) checks ok module ID 01: (0020) test of SCSI device 0 x 0 in progress module ID 01:... (4 Replies)
Discussion started by: ronst
4 Replies

5. Solaris

Boot problem

Hi everyone, I have sun fire280R machine before i it is installed with solaris5.9 now i want to upgrade it but it not booting from the cd rom ....OK prompt also not comming i dont have solaris keyboard to press stop-A key...i have a intel supported keyboard ...what may be the problem it is... (1 Reply)
Discussion started by: alakshmanrao
1 Replies

6. Solaris

flar restore with svm mirrors failing to create boot image

In a Solaris9 environment I'm trying to restore flash archive (flar) with SVM mirrored devices to same server via jumpstart server and it is failing to create boot file and drops down to a command prompt in single user mode, metastat -i and metastat -p output looks good when compared to the ones... (0 Replies)
Discussion started by: mbak
0 Replies

7. UNIX for Dummies Questions & Answers

boot problem

hello i have a sun server V890 and it stops booting after adding 2 CPUs modules and gives me the following error message: Enabling system bus....... Done Initializing CPUs......... Done Initializing boot memory.. RAM-Copy CRC failure!Can't start: No image found FATAL: Can't find/decompress... (0 Replies)
Discussion started by: bahjatm
0 Replies

8. Solaris

boot problem

hello i have a sun server V890 and it stops booting after adding 2 CPUs modules and gives me the following error message: Enabling system bus....... Done Initializing CPUs......... Done Initializing boot memory.. RAM-Copy CRC failure!Can't start: No image found FATAL: Can't find/decompress... (12 Replies)
Discussion started by: bahjatm
12 Replies

9. Solaris

Boot problem

Hi all, I have the the following SCSI diagnostic codes shown in the attached photo I suspect disk drive failure what can I do further to diagnose the disk. and if possible to boot into OS again. (5 Replies)
Discussion started by: h@foorsa.biz
5 Replies

10. Solaris

Problem boot Solaris

Hi I have a problem on a server, when he boot I have this type of message loop, do you know what it corresponds to ? ( requesting internet Adress for 0:3:ba:fa:33:91 ) Regards Sun Fire V240, No Keyboard Copyright 2007 Sun Microsystems, INC. All rights reserved. openboot 4.22.33,... (10 Replies)
Discussion started by: yoyo-tns
10 Replies
FILE2SM(1)							  ICI executables							FILE2SM(1)

NAME
file2sm - shared-memory linked list data ingestion test program SYNOPSIS
file2sm fileName DESCRIPTION
file2sm stress-tests shared-memory linked list data ingestion by repeatedly writing all text lines of the file named fileName to a shared- memory linked list that is the root object of a PSM partition named "file2sm". After writing each line to the linked list, file2sm gives a semaphore to indicate that the list is now non-empty. This is mainly for the benefit of the complementary test program sm2file(1). The operation of file2sm is cyclical. After copying all text lines of the source file to the linked list, file2sm appends an EOF line to the linked list, containing the text "*** End of the file ***", and prints a brief performance report: Processing I<lineCount> lines per second. Then it reopens the source file and starts appending the file's text lines to the linked list again. EXIT STATUS
0 file2sm has terminated. FILES
No configuration files are needed. ENVIRONMENT
No environment variables apply. DIAGNOSTICS
Can't attach to shared memory Operating system error. Check errtext, correct problem, and rerun. Can't manage shared memory. PSM error. Check for earlier diagnostic messages describing the cause of the error; correct problem and rerun. Can't create shared memory list. smlist error. Check for earlier diagnostic messages describing the cause of the error; correct problem and rerun. Can't create semaphore. ION system error. Check for earlier diagnostic messages describing the cause of the error; correct problem and rerun. Can't open input file Operating system error. Check errtext, correct problem, and rerun. Can't reopen input file Operating system error. Check errtext, correct problem, and rerun. Can't read from input file Operating system error. Check errtext, correct problem, and rerun. Ran out of memory. Nominal behavior. sm2file is not extracting data from the linked list quickly enough to prevent it from growing to consume all memory allocated to the test partition. BUGS
Report bugs to <ion-bugs@korgano.eecs.ohiou.edu> SEE ALSO
sm2file(1), smlist(3), psm(3) perl v5.14.2 2012-05-25 FILE2SM(1)
All times are GMT -4. The time now is 11:31 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy