Login or Register to Ask a Question and Join Our Community


Web Development

Trac styling

Login to Discuss or Reply to this Discussion in Our Community

 
Thread Tools Search this Thread
Top Forums Web Development Trac styling
# 1  
Old 09-30-2014
Trac styling
I am using trac (The Trac Project) for an intranet and want to ensure the styling is aligned with the corporate styling. After I have identified and amended the stylesheets (trac.css, admin.css etc), the changes are not propagated to the site. Perhaps the styling is interpreted in another way? How can I propagate trac stylesheet changes so that they are reflected on screen?
Login or Register to Ask a Question

Previous Thread | Next Thread
Login or Register to Ask a Question

LEARN ABOUT BSD

css

CSS(4)							     Kernel Interfaces Manual							    CSS(4)

NAME

       css - DEC IMP-11A LH/DH IMP interface

SYNOPSIS

       /sys/conf/SYSTEM:
	    NCSS css_controllers     # DEC/CSS IMP11-A ARPAnet IMP interface

DESCRIPTION

       The  css device provides a Local Host/Distant Host interface to an IMP.	It is normally used when participating in the DARPA Internet.  The
       controller itself is not accessible to users, but instead provides the hardware support to the IMP interface  described	in  imp(4).   When
       configuring, the imp(NIMP) pseudo-device is also included.

DIAGNOSTICS

       css%d:  not  alive.  The initialization routine was entered even though the device did not autoconfigure.  This is indicates a system prob-
       lem.

       css%d: can't initialize.  Insufficient UNIBUS resources existed to initialize the device.  This is likely to occur when the device  is  run
       on  a buffered data path on an 11/750 and other network interfaces are also configured to use buffered data paths, or when it is configured
       to use buffered data paths on an 11/730 (which has none).

       css%d: imp doesn't respond, icsr=%b.  The driver attempted to initialize the device, but the IMP failed to respond after 500 tries.   Check
       the cabling.

       css%d: stray output interrupt csr=%b.  An interrupt occurred when no output had previously been started.

       css%d: output error, ocsr=%b icsr=%b.  The device indicated a problem sending data on output.

       css%d: recv error, csr=%b.  The device indicated a problem receiving data on input.

       css%d: bad length=%d.  An input operation resulted in a data transfer of less than 0 or more than 1008 bytes of data into memory (according
       to the word count register).  This should never happen as the maximum size of a host-IMP message is 1008 bytes.

3rd Berkeley Distribution					  August 20, 1987							    CSS(4)