Red Hat

Hi folks,

i am using Oracle Red hat linux 6.5 64 bit operating system. but when i fire a command ifconfig -a it shows me no ip address has been assigned to this server except loop back address.then i done the following things


1)
#nm-connection-editor
2)
#service NetworkManager stop
#service NetworkManager start

3)ifconfig -a


but it doesn't show configured IP address even not able to pinh that IP address

Any advice to to configure Ip Address on Redhat linux 6.5 .

any suggestion, advice, link highly appreciated.

What have you done to set up the network so far?
Can you show us the output from:-

Code:

dmesg|grep "node addr"

Regards,
Robin

Hello Robin,

thanks for reply. i have done the following below thins to configure IP address

1)

Code:

#nm-connection-editor

2)

Code:

#service NetworkManager stop
#service NetworkManager start

Code:

3)ifconfig -a

it is not showing the IP Address which i have configured more over it showing an IP address 192.168.122.1 which is associated to NIC card by name Virbr0


and the out put for the command code which you provided dmesg|grep "node addr" doesn;t give any thing or result.

Note: i have installed Oracle Red Hat linux 6.5 on VM ware .


any advice or suggestion to do.

thanks & Regards.

Moderator's Comments:

Please use code tags next time for your code and data. Thanks

I know it might odd, but I don't think that you have any network cards, or if you do, they are not assigned to/discovered by your OS.

The device Virbr0 could well be a Virtual Bridge. Is this a virtual server?



Robin

Hi robin,

Yes it is VMWare

VMWare Work Station version 8.0.6 build-1035888. i am running Windows 7 Ultimate Service Pack 1 as Host OS.

Oh yes, I should have read to the end of your previous post where you say it's RHEL 6.5 on VMWare. Can you tell us what network cards you have assigned to the RHEL OS, according to the VMWare definition? It would seem that you might not have any.