hid2hci(8) [centos man page]

HID2HCI(8)																HID2HCI(8)

NAME

       hid2hci - Bluetooth HID to HCI mode switching utility

SYNOPSIS

       hid2hci [ options ]

DESCRIPTION

       hid2hci is used to set up switch supported Bluetooth devices into the HCI mode and back.

OPTIONS

       --mode= [hid, hci]
	      Sets the mode to switch the device into

       --method= [csr, logitech-hid, dell]
	      Which vendor method to use for switching the device.

       --devpath=
	      Specifies the device path in /sys

       --help Gives a list of possible options.

       AUTHOR
	      Written by Marcel Holtmann <marcel@holtmann.org>.

								   MAY 15, 2009 							HID2HCI(8)

RFCOMM(1)																 RFCOMM(1)

NAME

       rfcomm - RFCOMM configuration utility

SYNOPSIS

       rfcomm [ options ] < command > < dev >

DESCRIPTION

       rfcomm  is  used to set up, maintain, and inspect the RFCOMM configuration of the Bluetooth subsystem in the Linux kernel. If no command is
       given, or if the option -a is used, rfcomm prints information about the configured RFCOMM devices.

OPTIONS

       -h     Gives a list of possible commands.

       -a     Prints information about all configured RFCOMM devices.

       -i <hciX> | <bdaddr>
	      The command is applied to device hciX , which must be the name or the address of an installed Bluetooth device.  If  not	specified,
	      the command will be use the first available Bluetooth device.

COMMANDS

       show <dev>
	      Display the information about the specified device.

       conn <dev> [bdaddr] [channel]
	      Connect the RFCOMM device to the remote Bluetooth device on the specified channel. If no channel is specified, it will use the chan-
	      nel number 1. If also the Bluetooth address is left out, it tries to read the data from the config file. This command can be  termi-
	      nated with the key sequence CTRL-C.

       bind <dev> [bdaddr] [channel]
	      This  binds the RFCOMM device to a remote Bluetooth device. The command did not establish a connection to the remote device, it only
	      creates the binding. The connection will be establish right after an application tries to open the RFCOMM device.

       release <dev>
	      This command releases a defined RFCOMM binding.

AUTHOR

       Written by Marcel Holtmann <marcel@holtmann.org>.

								  APRIL 28, 2002							 RFCOMM(1)