FPA(4)							   BSD Kernel Interfaces Manual 						    FPA(4)

NAME

     fpa, fea -- device drivers for DEC FDDI controllers

SYNOPSIS

     device fpa
     device fea

     FreeBSD only:
     device fddi

DESCRIPTION

     The fpa and fea device drivers provide support for the DEC DEFPA PCI FDDI Controller and the DEC DEFEA EISA FDDI Controller, respectively.
     All variants of either controller are supported including the DAS and SAS configurations.

DIAGNOSTICS

     fea%d: error: desired IRQ of %d does not match device's actual IRQ (%d)  The device probe detected that the DEFEA board is configured for a
     different interrupt than the one specified in the kernel configuration file.

     fea%d: error: memory not enabled! ECU reconfiguration required  The device probe found that no device memory had been configured on the
     DEFEA.  Although the DEFEA can be configured with no device memory, this driver requires a minimum of 1K device memory to be set up.  The ECU
     (EISA Configuration Utility) will need to be run to change the settings.

SEE ALSO

     arp(4), netintro(4), ifconfig(8)

AUTHORS

     The fpa and fea device drivers and this manual page were written by Matt Thomas.

CAVEATS

     Normally, the device driver will not enable the reception of SMT frames.  However if the IFF_LINK1 flag is set, the device driver will enable
     the reception of SMT frames and pass them up to the Berkeley Packet Filter for processing.

BSD
								  March 13, 1995							       BSD