It's not exactly a question and more of a discussion.
I found very less graphics application being developed for linux system. I'm not really fond of graphics programming and have a very little knowledge about it. Can any one suggest me that whether linux lack in ghraphics support? or... (2 Replies)
Hi All,
I have a device driver that uses UARTserial port to write/read to-from a device.
That device driver is working fine on FC3 machine( kernel version 2.6.12)...
Now I am switching to FC9 (kernel version 2.6.25.11-97).I have changed the interrupt flag SA_INTERRUPT to IRQF_DISABLED... (0 Replies)
Hi All,
I have a device driver that uses UARTserial port to write/read to-from a device.
That device driver is working fine on FC3 machine( kernel version 2.6.12)...
Now I am switching to FC9 (kernel version 2.6.25.11-97).I have changed the interrupt flag SA_INTERRUPT to IRQF_DISABLED... (0 Replies)
I've been researching minimizeing Solaris 8 and found that on the web page http://www.sun.com/bigadmin/content/packagelist/s8u7PkgList/p2.html the package SUNWglmr
is listed as "rasctrl environment monitoring driver for i2c, (Root) (32-bit)" while in the document "Solaris 8 minimize-updt1.pdf"... (1 Reply)
EN(4) BSD Kernel Interfaces Manual EN(4)NAME
en -- device driver for Midway-based ATM interfaces
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device en
device atm
device utopia
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
if_en_load="YES"
DESCRIPTION
The en device driver supports Midway-based ATM interfaces including the Efficient Networks, Inc. ENI-155 and Adaptec ANA-59x0. Midway is an
AAL5 SAR (Segmentation and Reassembly) chip.
For configuring the card for IP see natmip(4).
The following sysctls are recognized by the driver additionally to those handled by utopia(4):
hw.atm.enX.istats
Contains an array of uint32_t with internal driver statistics.
hw.atm.enX.debug
This is a bit map of debugging options. This variable is only available when the driver is compiled with debugging support.
The driver supports the media options sdh, noscramb and unassigned (see utopia(4)).
DIAGNOSTICS
en0 <Efficient Networks ENI-155p> rev 0 int a irq 5 on pci0:16
en0: ATM midway v0, board IDs 6.0, Utopia (pipelined), 512KB on-board RAM
en0: maximum DMA burst length = 64 bytes
en0: 7 32KB receive buffers, 8 32KB transmit buffers allocated
CAVEATS
The driver extensively uses DMA on PCI. The first generation PCI chipsets do not work or exhibit poor performance.
SEE ALSO natm(4), natmip(4), utopia(4), ifconfig(8), route(8)AUTHORS
Chuck Cranor of Washington University implemented en driver in 1996 for NetBSD.
BSD July 16, 2005 BSD