Visit Our UNIX and Linux User Community


Modem


 
Thread Tools Search this Thread
Top Forums UNIX for Dummies Questions & Answers Modem
# 1  
Old 07-09-2002
Network Modem

Pleaseee... Helpppp.... !!!

I am using SCO Open Server 5.05. Recently, i have upgraded the system which means transfer all apps and data to the new system. Everything work well except one thing. On my old system i have an external modem which to dial out. Now that i use the same modem on the new system which doesn't seems to work..... Everytime i tried to dial out.... All i got is " CAN NOT OPEN MODEM ". What could be the problem ? And how should I correct this problem... Pleaseee Helpppp....

Thank you so much for you time
# 2  
Old 07-09-2002
Don't know if this will help or not - pcunix.com SCO modem
# 3  
Old 07-09-2002
Or even better - SCO - how to set up a modem
# 4  
Old 07-09-2002
Cannot open modem.. Is the Modem connected on your machine ? is it On ? Any messages or error code during bootup ? Also state what modem are you using.
# 5  
Old 07-11-2002
Modem

Hi... Thanks for all your help!
I have found the problem. Modem has conflict address. What i did was, i went into CMOS setup and change serial port from IRQ4 to IRQ3 and voala..... The modem is working fine now.

Again, thank you for all your help.
 

Previous Thread | Next Thread
Test Your Knowledge in Computers #1005
Difficulty: Easy
Regarding a circle, one full turn of the circle is equal to 2 radians.
True or False?

10 More Discussions You Might Find Interesting

1. IP Networking

modem detection

How to get information that where is my modem configured in /dev. I have two modems configured in my device .. one is USB and other is PCI modem.. USB is detected as /dev/USB0. but how to see about PCI modem? (0 Replies)
Discussion started by: s123.radha
0 Replies

2. Solaris

Modem

hi folks, i am looking for a analog modem to use it with a solaris9 sparc mashine. as far as i know, solaris communicates with the modem using AT-commands. so do i need a special modem for solaris or just a modem? i am open for everything. PCI-modem, seriell modem, usb modem. what are you using? i... (1 Reply)
Discussion started by: pressy
1 Replies

3. Solaris

Is the cable you are using a null modem cable or a modem cable

Hi all, Is there any difference between a null modem cable or a modem cable ? i assume that a null modem cable is a normal cable that i used from cpu serial ports to a modem for dialup. please correct if i am wrong, thks (2 Replies)
Discussion started by: waterbear
2 Replies

4. UNIX for Dummies Questions & Answers

Dial-Up Modem

Im using Kinternet with a Lucent modem on Suse 9.0 Ive installed the ltmodem driver and suse says the device is ready and configured. Ive configured it at /dev/ttyS0 This is the log that Kinternet gives after trying to connect: SuSE Meta pppd (smpppd-ifcfg), Version 1.06 on linux. Status... (0 Replies)
Discussion started by: Synbios
0 Replies

5. UNIX for Dummies Questions & Answers

Modem - Test /dev/modem

Ok. I tried following the directions from some of the other threads, but I've hit a road block. I have red hat 7.3 and I installed the hcf package: hcfpcimodem-0.99lnxtbeta03042700k2.4.18_3-1rh.i386.rpm It installed ok, no errors, but I still can't get linux to find my modem. I've tried... (2 Replies)
Discussion started by: lawadm1
2 Replies

6. UNIX for Dummies Questions & Answers

modem

I have got Suse 8.0 by using a modem (US Robotics 56K Faxmodem Ext). During connection i got the error 16. I tried it under RedHat and Mandrake too.....same problem. What can i do ? Thanx...a lot... Logfile: SuSE Meta pppd (smpppd), Version 0.73 on zuhause. wwwoffle not is running ... (1 Reply)
Discussion started by: Pennywize
1 Replies

7. UNIX for Dummies Questions & Answers

Modem Volume

Specs: Dlink DFE-560EL external modem. RedHat 7.1 How do you turn off the modem volume? I am getting annoyed of it beeping everytime I use it but there is no switch on the hardware to tune down the volume. I have tried using minicom and use the following commands: ATL0 ATM0 Next, I... (2 Replies)
Discussion started by: arz
2 Replies

8. UNIX for Dummies Questions & Answers

Modem problem: "Sorry, modem is busy"

Hi! I have a little prob with dialing up to the internet... When I try connect, it says "Sorry, modem is busy"... Specs: Laptop 56K modem Slackware 8.0 Kernel 2.4.5 Cheers;) (4 Replies)
Discussion started by: satan404
4 Replies

9. UNIX for Advanced & Expert Users

Modem

I've spent enough time trying to put on work Lucent Winmodem in my armada M300 (compaq laptop) I use Mandrake 8.0 but as soon as i get connected and prompmts appears modem shutsdown. Does any one had a similar situation, solved it? cheers (2 Replies)
Discussion started by: alex blanco
2 Replies

10. UNIX for Dummies Questions & Answers

Modem on HP-UX 10.20

Hi everyone I am having some real difficulties getting a dial in modem to work on one of my HP boxes. It's a mux modem on port 7 which I have set up at 9600 baud. I can dial in, the handshakes are completed, but then it returns incoherent characters on the emulation screen. I think my dial in... (1 Reply)
Discussion started by: alwayslearningunix
1 Replies

Featured Tech Videos