9 More Discussions You Might Find Interesting
I have some doubt about the NIC device on my AIX box.
When using lsdev command
/ > lsdev -Cc adapter | grep en
ent0 Available 03-00 2-Port 10/100/1000 Base-TX PCI-Express Adapter (14104003)
ent1 Available 03-01 2-Port 10/100/1000 Base-TX PCI-Express Adapter (14104003)
ent2... (11 Replies)
Discussion started by: Phat
2. UNIX for Beginners Questions & Answers
I have Xubuntu 18.04 installed on my PC. I have created a 10G .img image file created by QEMU-IMG. I have installed inside of it Solaris 9 SPARC edition . If I try and mount the image file as a loop device (using sudo losetup /dev/loop0 /path-to-img-file) I can only mount it as read only.
... (1 Reply)
Discussion started by: alphatron150
3. Red Hat
I want tune my NIC's rps, rfs and xps value.
In my system I have two NIC (eth0, eth1) and I have a bond0 ( eth0, eth1).
Here is the question? Which device should I modify ?
eth0 and eth1? or just modify bond0 or modify all device (eth0, eth1, bond0)
Any advice is welcome.... (0 Replies)
Discussion started by: nnnnnnine
we asked to create a sender and receiver for a signals. sender knows his receiver by it's(receiver) PID .... my question is if i go to other computer and run my program will the pid chages than the first pid i got from old computer? (2 Replies)
Discussion started by: fwrlfo
how can we change the nic card speed
please explain through commands & steps ????
and i want to change NIC speed 100 --1000Mbps
and what is full & half duplex gives
thanks in advance (6 Replies)
Discussion started by: wkbn86
6. UNIX for Dummies Questions & Answers
I disconected external device which was configured as rmt0. When I connect it again and run cfgmgr device name has changed (internal drive which was rmt1 is now rmt0 and external drive was rmt0 and is rmt1) and I dont know how to back it out. The thing is that for all backups I use new modell... (2 Replies)
Discussion started by: fraydey
7. UNIX for Advanced & Expert Users
Hello and thank you in advance for any assistance.
Working with SCO 5.0.5 our SCSI tape device is no longer working.
Before we replace the unit I want to verify it's not related to a change
someone may have made via mkdev tape.
For years the boot message would list the tape device as this:... (1 Reply)
Discussion started by: sighbrrguy
8. Red Hat
this is the situation.
I have a server with redhat Advance Server 3 and the operating system is installed in /dev/sda disk... when i include new Luns dinamically they take the following special files /dev/sdb and /dev/sdc.... ok.. until now is everything ok... but the problem begins... (2 Replies)
Discussion started by: lenux78
I tried to use this command
ndd -set /dev/eri adv_1000fdx_cap 1
but i get a "operation failed, Invalid argument"
anyone can help ? Thanks (5 Replies)
Discussion started by: DarReNz