9 More Discussions You Might Find Interesting
1. Red Hat
Dear Expert,
I 've installed Redhat linux AS3, My machine having Inbuild network card (Intel(R) 82566DM-2 Gigabit Network Connection).
I've downloaded e1000e-2.3.2 from Intel site, but its not working for my machine. I'm unable to configure the Network.
ifconfig eth0 xx.xx.xx.xx netmask... (0 Replies)
Discussion started by: Mohammed Faiz
0 Replies
2. Solaris
Hi All,
Anyone has configured a Sunix Sata S150 card (AKA Initio Inic-1622) + disk in a Solaris10/x86 05/09 system? I wondered what to do to get it running. The Sunix card does not come with a Solaris driver ;-(
The card is seen by the system as the prtconf -v output shows (see below at the... (0 Replies)
Discussion started by: longwave
0 Replies
3. Solaris
I have installed solaris10 x86 on HP DL380 G5 Server, but network card is not getting detected.
i have installed the network driver, downloaded from the following link
HP ProLiant DL380 G5 Server series- Download drivers and software - HP Business Support Center
Can any one suggest me how to... (1 Reply)
Discussion started by: raj.chinnu
1 Replies
4. UNIX for Dummies Questions & Answers
I have three network cards in my unix box. I need to figure out which card corresponds to an assigned IP address. If there some command in unix I can use to make an ethernet interface blink?
Any advice would be appreciated. (6 Replies)
Discussion started by: mojoman
6 Replies
5. SCO
hi all
i have installed SCO 5.0.5 on a "Netfinity 5000" IBM server. But the OS is not detecting the lan card. how can i detect it.... help and thanks in advance .
bidhayak (3 Replies)
Discussion started by: bidhayakm
3 Replies
6. IP Networking
I have an E420 server that has a TPE Slot / NIC installed.
However there is no interface file installed eg /etc/hostname.hme0 or equivalent.
I have placed a private ip entry int the hosts file to accompany the loop back entry i.e.
127.0.0.1 localhost
172.16.0.10 loghost se420
... (1 Reply)
Discussion started by: jimthompson
1 Replies
7. UNIX for Advanced & Expert Users
I have an E420 server that has a TPE Slot / NIC installed.
However there is no interface file installed eg /etc/hostname.hme0 or equivalent.
I have placed a private ip entry int the hosts file to accompany the loop back entry i.e.
127.0.0.1 localhost
172.16.0.10 loghost se420
... (1 Reply)
Discussion started by: jimthompson
1 Replies
8. UNIX for Advanced & Expert Users
I have been having trouble with my sis900 neytwork card in slacwkare linux. I tried to modprobe the sis900, it didnt give me any errors but it didnt load it. so I put in a realtek 8139 network card and tried it too. These are the errors i get with the two cards when trying to do insmod on either of... (3 Replies)
Discussion started by: The Fridgerator
3 Replies
9. IP Networking
I have a UnixWare 2 server that has an ISA 3Com NIC that has just a BNC connector on it. I want to remove this and install an ISA 3Com NIC that has a BNC/RJ45 connector. What steps do I have to go through to successfully complete this? Thye are almost the exact same cards except for the... (1 Reply)
Discussion started by: cparks
1 Replies