10 More Discussions You Might Find Interesting
1. AIX
Hi
I've just upgraded OS - using "Migration with nimadm". The Nim master is a Power 6 server, and the source is 6100-09-04-1441.
The migration was successful with a Power 6 - Nim client, but there was a problem with Power 5 - Nim client : the OS remained 6100-00-09-0920
icapp1:/]oslevel -s... (1 Reply)
Discussion started by: bobochacha29
1 Replies
2. AIX
Hello AIX experts,
I have 7038-6M2 server, its operating system is AIX 5.2, and its firmware is 3K041021
After some searching on net, I tried to update its firmware level to 3K080425, so I downloaded the required rpm, and followed the steps.
After rebooting the server, it stopped and an error... (6 Replies)
Discussion started by: Mohannad
6 Replies
3. Ubuntu
Hi folks,
Ubuntu 9.04
I have an old box not running for years. I just dig it out from the store room. On running;
$ sudo aptitude update
......
......
Err http://hk.archive.ubuntu.com jaunty/main Packages
404 Not Found
Err http://hk.archive.ubuntu.com jaunty/restricted Packages
... (1 Reply)
Discussion started by: satimis
1 Replies
4. Solaris
I have a Solaris 10 OS having kernal patch level 138888-03 on several servers but recenlty I upgraded it into 142900-12 on some T-Series servers & v890 server after install them my syslog is increasing at a rate of 1GB on average on all servers . I believe its a bug, can somebody help me in... (1 Reply)
Discussion started by: sb200
1 Replies
5. Shell Programming and Scripting
Guys,
I have a script that should change one of the configuration Parameter in a http accelerator, this config change which will halt http traffic into device. So I have designed a script which should do these changes. But after executing this script, found that one of the input variable is not... (8 Replies)
Discussion started by: raghunsi
8 Replies
6. Solaris
Hi guys I have a Sun Fire X4500 running Solaris 10 OS. It has 48 TB Hard Disk. I need to format it and make 3 partitions. Could someone give me a link or help me with this.
Thank you (1 Reply)
Discussion started by: bharu_sri
1 Replies
7. Solaris
when I type start /SP/console... the console shows up but i cannot type anything over there. I do not understand what might be the reason for that.
-> start /SP/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started. To stop, type ESC (
I pressed enter many... (8 Replies)
Discussion started by: bharu_sri
8 Replies
8. Solaris
I have X4500 machine with solaris 10 OS and software version 5.10. The firmware version is 1.1.1 and I am planning to upgrade the firmware.
C H A P T E R 1 - Flash Upgrading Your Server to Software Release 1.2
I referred to the above link to do so. But, I do not understand what is the... (6 Replies)
Discussion started by: bharu_sri
6 Replies
9. Solaris
I get an error message when I try to upgrade the firmware. The error message is displayed below.
Image has no uboot. DO NOT RESET OR YOU WILL BRICK THE ILOM. Please retry with the correct image
I do not understand anything about this message. May I know what does it mean ? How can I get rid... (6 Replies)
Discussion started by: bharu_sri
6 Replies
10. Solaris
I have solaris X4500 with ILOM version 1.1.1. I want to update the firmware. I know that we need to use
load -source tftp://tftpserver/image file
But I do not understand what is the IP address of the tftp server that we need to type in there.
Kindly, help me with this.
Thank you (5 Replies)
Discussion started by: bharu_sri
5 Replies