Hi there!
I just purchased and hooked up to my Sun Blade 1000 running SunOs 5.9, a 20.1-in flat panel LCD monitor. I rebooted the system and the input signal to the monitor was fine at boot up until it started X-win, then the following message was displayed:
Video Input
2 D-SUB
Out of Range.
Consulting the documentation that came with the monitor, I get this:
OUT OF RANGE: When input signal is non-supported timing or the video signal doesn't have proper timing, the “Out of Range” window will appear.
I suspect that I need to set the resolution and timing somewhere, but I am not sure how and where. I also suspect that will have to interrupt starting X-win and work from the terminal mode as root, since I get nothing on the display when X-win is started. The recommended resolution and frequency: 1600x1200 @ 60 Hz.
Any assistance would be appreciated...
Thank you!