Solaris Network question


 
Thread Tools Search this Thread
Operating Systems Solaris Solaris Network question
# 1  
Old 02-24-2006
Solaris Network question

I have a machine that has developed a strange network problem. Anytime it sends an FTP file somewherwe, no problem. When it is the target machine, extremely slow. I checked the /var/adm/messages file and found a few of these:
SUNW,hme0 : No response from Ethernet network : Link down -- cable problem?


I checked the hme status codes. 100 Meg, Full Duplex. All OK.

Could this be a bad cable or port of even NIC card?
# 2  
Old 02-24-2006
yes it could be any of those, but the cable is most likely.
# 3  
Old 02-27-2006
Did you find what was wrong ?

What's your environment ? Is this box connected to a switch ? Does the box have more than one ethernet port ? [If so, are both connected ?]

I agree that any physical problem is more likely to be a cable (or part thereof) but the "send OK, Receive BAD" part of this problem may be pointing to something else as a cause.

There is a slim chance, if this is a SPARC conected to a Cisco switch, that this *might* be an auto-negotiation problem. But they fixed all that a while back, and I know nowhere near enough 'data' to make THAT kind of assumption.
====
Login or Register to Ask a Question

Previous Thread | Next Thread

10 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

Redhat - network question

Hi, I am on Redhat 5. on the /etc/sysconfig/network file I don't see GATEWAY as one line. I also checked /etc/sysconfig/network-scripts/ifcfg-eth0. I don't see GATEWAY. But on the server. But when I do netstat -rn. I see many address. Is there some other settings ? ... (2 Replies)
Discussion started by: samnyc
2 Replies

2. Linux

(ASK) Question about linux network...

hi all, im linux nubie n want to ask, 1. how to access the windows pc? if from windows to windows, we can use : start-run-\\192.168.1.1\e$ now, how about from linux (fedora) n want to access to windows drive? if I use ssh from linux to windows, ssh 192.168.6.171 ssh: connect... (6 Replies)
Discussion started by: busoh.sensen
6 Replies

3. IP Networking

Network question

Folks; I have 2 SUSE servers similar in all configuration & both on the same network (192.168.151.10 & 192.168.151.11) with the same default gateway of 192.168.151.1 and the same netmask of 255.255.255.0 and the same firewall configuration the first one works fine and i can ssh to it & i can... (3 Replies)
Discussion started by: Katkota
3 Replies

4. IP Networking

network question

Hi here is my question; any help would be appreciated The Linux system pokey has two Ethernet cards. The first Ethernet card is connected to a companywide TCP/IP network covering the addresses 87.65.43.xx, where pokey's address is 87.65.43.21. The second Ethernet interface is connected to a... (2 Replies)
Discussion started by: scofiled83
2 Replies

5. UNIX for Dummies Questions & Answers

multi-network question

Hi, I have a linux machine connected to 2 networks, with devices eth0 and eth1. When I give the command host whatever, how do I now which network is searched for the DNS's ? Is there a default ethernet device for network related commands ? How do I change it ? :confused: (2 Replies)
Discussion started by: mik
2 Replies

6. Solaris

Solaris 10 Network Question

I am new to Solaris and have been searching around for this answer and I think I figured it out but I wanted to run it by you folks. I was trying to figure out if the network on this Solaris 10 machine was set up for 100 Full Duplex. I think from this output that it is 100 full duplex, am I... (2 Replies)
Discussion started by: scotbuff
2 Replies

7. UNIX for Dummies Questions & Answers

network set up question

1) how do i know my NIC speed if its 10//100??? 2)how do i setup by NIC to full duplex 3) any help on setting up etherchannel for NIC failover (1 Reply)
Discussion started by: karthikosu
1 Replies

8. UNIX for Dummies Questions & Answers

Network noobie question

This is my first attempt in installing a netbsd ever. I'm trying to get myself familiar with some commands and how things work in unix and so far i never knew its this fun. Anyway, unix is our elective here in school and school is gonna start 2 weeks. I'm just trying to get a headstart on this :D... (2 Replies)
Discussion started by: 3rr0r_3rr0r
2 Replies

9. Linux

question about accepr() in network programming

I'm working on my homework to write a chatroom program. Different users can be on-line at the same and talk to each other. I found that each time I invoked the accept function. A new socket was created. I don't how can I receive message from the client who is already on-line and send it to others.... (0 Replies)
Discussion started by: niukun
0 Replies

10. UNIX for Dummies Questions & Answers

Network question

Hey, Just need a little help I'm not sure wat I should do. We have several little networks setup for testing different things. One of these networks we need to have running at full dulpex. Right now we run 2 hubs (to go off to 2 differnt parts) and they are half dulpex hubs. Is is... (1 Reply)
Discussion started by: merlin
1 Replies
Login or Register to Ask a Question