Hi,
I am trying to configure Solaris 10 for Internet Connection.
I have a PC (Celeron 1.7Ghz, 512 MB RAM, Gigabyte 8LD Motherboard).
The Wireless Telephone Specs are:
TATA Indicom Walky.
Further product details are as follows ( I did not understand most of what it says. I have
given it here in case some of the experienced users probably would decipher this
)
It's an Axxestel Model AXW-P800. It's a CDMA 1xRTT Fixed Wireless Phone that has the
frequency range: Tx: 824~849Mhz and Rx:869 ~ 894Mhz.
It has a Channel Bandwidth CDMA 1.25MHz.
The Internet Access Cable provided with the phone is a Parallel Cable, one end goes in the
Wireless Phone and the other in the computer. The CD provided with the cable has Windows
Only software and hence I was able to get it to work, since it merely was a matter of a few
clicks.
I referred the "Configuring high-speed dialup on Solaris 7 and Solaris 8" on
www.kempston.net/ and got to the part where I had to type
# tip /dev/cua/a
Upon typing this command, I got the Connected message, but then I could not type anything
after that. The document suggests that I should type ATZ, but the terminal would not accept
any input from the keyboard. So I tried opening a new window and tried, but the same thing
happens ( I was trying these commands in gnome terminal under JDS). Since the admintool is
not available in Solaris 10, I tried using SMC, and was able to get the parallel port
configured for dial out as suggested. After that I tried the command mentioned above and it
does not work.
I tried contacting the Phone Tech Support, but they only support Windows.
I would really be thankful if someone could guide me to a website that would show me how to
get it to work.
Regards,
Pritesh
***********
closed: double threads
***********
07-31-2005
