9 More Discussions You Might Find Interesting
1. Solaris
Hi, hoping someone can help, its been a while since I used Solaris.
After creating a NGZ (non global zone), the NGZ can access the GZ (Global Zone) and the GZ can access the NGZ (using ssh, zlogin)
However, the NGZ cannot access any other netwqork devices, it can't even see the default router
... (2 Replies)
Discussion started by: GazinLincoln
2 Replies
2. Solaris
Hello all,
I just want to update the timezone file with new file to update the time, so the zone in /etc/TIMEZONE will be the same but the file it refers to will be changed, and the local time should be changed, can this take effect without rebooting Solaris 10? (9 Replies)
Discussion started by: Amr.Es
9 Replies
3. UNIX for Advanced & Expert Users
Dear all,
recently, I migrated a solaris zone from one host to another. The zone was inside of a zpool. The zpool cotains two volumes.
I did the following:
host1:
$ zlogin zone1 shutdown -y -g0 -i0 #Zone status changes from running to installed
$ zpool export zone1
host2:
$ zpool... (2 Replies)
Discussion started by: custos
2 Replies
4. Solaris
can some one help me out as it is showing 2 different time zones in global zone and nonglobal zone .In global zone it is showing in GMT while in nonglobal zone i it showing as PDT.
System in running with solaris 10 (3 Replies)
Discussion started by: ravijanjanam12
3 Replies
5. Solaris
I have two physical servers, with zones that mount local storage.
We were using "raw device" in the zonecfg to point to a metadevice on the global zone (it was not mounted in the global zone at any point).
It failed to mount on every boot because the directory existed in the zone.
I... (6 Replies)
Discussion started by: BG_JrAdmin
6 Replies
6. Solaris
Hi Greetings...
I have an issue in connecting the zone from outside the network and it is because of default gateway. I can ping default gateway from inside the zone and not able to ping from global zone due to different VLAN issue. If i add two different gateways and restart network services,... (2 Replies)
Discussion started by: vvpotugunta
2 Replies
7. Solaris
Hi All,
I have Solaris-10 M4000 server with VxVM file-system and 7 zones. I rebooted the server and after that one of the zone shows me in running state, but after zlogin, it is showing no df and other output. It is also throwing lot of core dumps
# uname -a
SunOS tssoaq01-ztbgps17 5.10... (7 Replies)
Discussion started by: solaris_1977
7 Replies
8. Solaris
Hello.
I have a problem where the non global zone does not reboot when I issue
init 6 from withinit.
I logon to the zone do init 6 can the see "shuttingdown on signal 15" message but nothing more happens. after 10 minutes in var adm messages there is no more information written after the... (2 Replies)
Discussion started by: vettec3
2 Replies
9. Solaris
Hi,
I have a primary/slave Bind 9 setup running on a Solaris 10 platform. Everything is hunky dorey, except for when I make a zone file change and up the serial the file that is transferred to the slave looses all its comments, and the entries are place in alphabetical order.
I administer many... (1 Reply)
Discussion started by: fulhamfcboy
1 Replies