9 More Discussions You Might Find Interesting
1. Solaris
All I'm running an OpenSolaris system (Nexenta). When doing a svcs I see that/network/smb/server is in maintenance mode.
I have run a clear on the service and restarted. I see the same service show online* for a bit but then, enters maintenance every time.
In the service log I... (2 Replies)
Discussion started by: dcpatriot
2 Replies
2. Solaris
Dear All,
http:apache2 service on my node is continuously in maintenance mode.
I have tried to enable and disable the service but nothing works.
root@ops # svcs -a | grep apache2
maintenance 15:46:37 svc:/network/http:apache2
When I reboot the system, I get the following error:
... (1 Reply)
Discussion started by: Junaid Subhani
1 Replies
3. Solaris
After a memory upgrade all network interfaces are misconfigued. How do i resolve this issue. Below are some out puts.thanks.
ifconfig: plumb: SIOCLIFADDIF: eg000g0:2: no such interface
# ifconfig eg1000g0:2 plumb
ifconfig: plumb: SIOCLIFADDIF: eg1000g0:2: no such interface
# ifconfig... (2 Replies)
Discussion started by: andersonedouard
2 Replies
4. Solaris
Hello Friends,
I need to change network filesystem status as online but it always seems in maintenance mode, I appreciate your any suggestion to change its state as online.
shell>svcadm enable svc:/system/filesystem/local
shell>svcs -l svc:/system/filesystem/local
fmri ... (4 Replies)
Discussion started by: EAGL€
4 Replies
5. AIX
Hello All,
Can anybody please tell me what is the maximum limit of Physical IBM Power Machine which can be handled by single HMC at a single point of time?
Thanks,
Jenish (1 Reply)
Discussion started by: jenish_shah
1 Replies
6. UNIX for Dummies Questions & Answers
I was in smit, checking on disc space, etc. and it appears that one of our physical volumes that is part of a large volume group, has no free physical partitions. The server is running AIX 5.1. What would be the advisable step to take in this instance? (9 Replies)
Discussion started by: markper
9 Replies
7. Solaris
How do you test the physical network connection of an interface in solaris. I know that if you have an active connection and the cable gets yanked, you can look in the messages file to check for link failure messages. But is there any better way to see if you have good layer 2 connectivity? (1 Reply)
Discussion started by: tjlst15
1 Replies
8. UNIX for Dummies Questions & Answers
Hello,
I need explanations about physical disks and physical volumes. What is the difference between these 2 things?
In fact, i am trying to understand what the AIX lspv2command does.
Thank you in advance. (2 Replies)
Discussion started by: VeroL
2 Replies
9. Cybersecurity
Hi all
I am facing some problem with network card
i am using solaris8 and on sunultra10 .As it is my firewal machine i have got on backup harddisk for any emergency.
In one hardidsk while installation only hme0 interface was configured and in the backup hard disk qfe0/hme0 both are... (0 Replies)
Discussion started by: Prafulla
0 Replies