10 More Discussions You Might Find Interesting
1. Red Hat
am try to create another network card as virtual eth0:1
but when i restart the server it want be appear i have to create it again what is the solution for this . (6 Replies)
Discussion started by: leganti
Trying to set or modify the randomly set hostID of a Solaris 10 virtual/guest machine that I installed on a Windows-XP host machine (using Virtual Box 4.1.12).
I was able to set/modify the hostname of the Solaris 10 virtual/guest machine during installation as well as via the Virtual Box... (4 Replies)
Discussion started by: Matt_VB
I couldn't install my nic in solaris 10. I compiled and added
the driver but failed to attach the driver and ifconfig output
shows only loopback dev. Please see the following output and tell
me whether my nic has been detected and why the driver failed to
My nic is detected in linux... (0 Replies)
Discussion started by: vectrum
4. OS X (Apple)
I tried to use the command
sudo ifconfig en0 ether xx:xx:xx:xx:xx:xx
to do mac spoofing for internet connection in my office. It works only for 5 minutes. Every time after about 5mins, the Internet will be disconnected. :wall:
Any one knows how to solve this problem? Thanks. (6 Replies)
Discussion started by: andrewust
does any body know how to create Virtual NIC in Solaris 10
if any one have good article or reference
kindly provide me
i try to Google
but i didn't find good one (7 Replies)
Discussion started by: jamisux
There is a question in the SCO section asking for information on how to change the MAC address of a NIC. Is there a valid reason for wanting to change the MAC address? (1 Reply)
Discussion started by: jgt
how can I determine which NIC card is virtual NIC Card
which condition can make a decision
Does HP UX have Virtual Network Adapter Concept
if ,it has
where I can Find if I Install Virutal Network Adapter
or which command that i can get it
or which software can generate
thanks (2 Replies)
Discussion started by: alert0919
We have a 4 port Sun gigaswift NIC card on our sun fire server.
If the card is a physical one I know how to check the settings/speed. But since this is a virtual card with 4 ports , I am not sure as how we can check the settings.
root:/> ifconfig -a
lo0:... (3 Replies)
Discussion started by: pray44u
9. IP Networking
I bound a virtual IP to a network card on my E450 server and I am getting this error when I reboot the server, saying, " retrying host, RPC time out. I had to break this sequence and allow other services to load. Of course they didn't load properly. Please how can I sort this out? I do need... (8 Replies)
Discussion started by: Ronny
10. UNIX for Advanced & Expert Users
I have a need to software change the MAC address of a NIC in a Sparc Ultra 10 - I believe there is a command that allows to do this at boot up?
Is it a missing (to me) part of ifconfig ?
If so, what is the syntax?
All replies gratefully received !
Andrew (3 Replies)
Discussion started by: wretch