Login or Register to Ask a Question and Join Our Community


Solaris

Serial Split Brain detected in solaris10

Login to Discuss or Reply to this Discussion in Our Community

 
Thread Tools Search this Thread
Operating Systems Solaris Serial Split Brain detected in solaris10
# 15  
Old 04-02-2010
Ok, ran that command,

VxVM vxvol ERROR V-5-1-1367 Volume myapp-vxvol: not ENABLED, cannot recover subdisks
# 16  
Old 04-02-2010
I changed my mind on the command to use knowing that one would fail, see previous post(updated)
# 17  
Old 04-02-2010
vxrecover -g myapp-dg myapp-vxvol

went without any error but the output of vxprint -htr is same in my earlier post where I posted vxprint -htr

---------- Post updated at 07:47 PM ---------- Previous update was at 07:46 PM ----------

And, no task in vxtask list this time as well.
# 18  
Old 04-02-2010
That's ok.

Code:
vxvol -g myapp-dg -o delayrecover start myapp-vxvol

# 19  
Old 04-02-2010
O/p for last command is,

VxVM vxvol ERROR V-5-1-1236 Volume myapp-vxvol is not startable; Raid5 plex does not map the entire volume length
# 20  
Old 04-02-2010
ok, give me a few minutes to go through the current states.

---------- Post updated at 02:04 AM ---------- Previous update was at 02:01 AM ----------

Can I see the output of:

Code:
vxrecover -V

# 21  
Old 04-02-2010
Okay, no problem.

Meanwhile I tried the vxvol stop command and your start command again. O/p for start is same as I got earlier but vxprint has more DISABLED stats now.

vxprint -htr
Code:
Disk group: myapp-dg

DG NAME         NCONFIG      NLOG     MINORS   GROUP-ID
ST NAME         STATE        DM_CNT   SPARE_CNT         APPVOL_CNT
DM NAME         DEVICE       TYPE     PRIVLEN  PUBLEN   STATE
RV NAME         RLINK_CNT    KSTATE   STATE    PRIMARY  DATAVOLS  SRL
RL NAME         RVG          KSTATE   STATE    REM_HOST REM_DG    REM_RLNK
CO NAME         CACHEVOL     KSTATE   STATE
VT NAME         RVG          KSTATE   STATE    NVOLUME
V  NAME         RVG/VSET/CO  KSTATE   STATE    LENGTH   READPOL   PREFPLEX UTYPE
PL NAME         VOLUME       KSTATE   STATE    LENGTH   LAYOUT    NCOL/WID MODE
SD NAME         PLEX         DISK     DISKOFFS LENGTH   [COL/]OFF DEVICE   MODE
SV NAME         PLEX         VOLNAME  NVOLLAYR LENGTH   [COL/]OFF AM/NM    MODE
SC NAME         PLEX         CACHE    DISKOFFS LENGTH   [COL/]OFF DEVICE   MODE
DC NAME         PARENTVOL    LOGVOL
SP NAME         SNAPVOL      DCO
EX NAME         ASSOC        VC                       PERMS    MODE     STATE
SR NAME         KSTATE

dg myapp-dg    default      default  95000    1267475668.79.servername

dm myapp-dg01  c1t2d0s2     auto     65536    143283520 SPARE
dm myapp-dg02  c1t3d0s2     auto     65536    143283520 -
dm myapp-dg03  c2t0d0s2     auto     65536    71061376 -
dm myapp-dg04  c2t1d0s2     auto     65536    71061376 -
dm myapp-dg05  c2t2d0s2     auto     65536    71061376 -
dm myapp-dg06  c2t8d0s2     auto     65536    71061376 -
dm myapp-dg07  c2t9d0s2     auto     65536    71061376 -
dm myapp-dg08  c2t10d0s2    auto     65536    71061376 -

v  myapp-vxvol -            DISABLED CLEAN    355305600 RAID     -        raid5
pl myapp-vxvol-01 myapp-vxvol DISABLED(SPARSE) ACTIVE 355305600 RAID 6/32 RW
sd myapp-dg02-01 myapp-vxvol-01 myapp-dg02 0 71061120 0/0      c1t3d0   ENA
sd myapp-dg03-01 myapp-vxvol-01 myapp-dg03 0 71061120 1/0      c2t0d0   RCOV
sd myapp-dg04-01 myapp-vxvol-01 myapp-dg04 0 71061120 2/0      c2t1d0   RCOV
sd myapp-dg05-01 myapp-vxvol-01 myapp-dg05 0 71061120 3/0      c2t2d0   RCOV
sd myapp-dg06-01 myapp-vxvol-01 myapp-dg06 0 71061120 4/0      c2t8d0   RCOV
sd myapp-dg07-01 myapp-vxvol-01 myapp-dg07 0 71061120 5/0      c2t9d0   ENA
pl myapp-vxvol-03 myapp-vxvol DISABLED LOG   5760     CONCAT    -        RW
sd myapp-dg01-01 myapp-vxvol-03 myapp-dg01 0 5760    0         c1t2d0   ENA



---------- Post updated at 08:07 PM ---------- Previous update was at 08:06 PM ----------

vxrecover -V
-bash-3.00#
Login or Register to Ask a Question

Previous Thread | Next Thread

5 More Discussions You Might Find Interesting

1. What is on Your Mind?

The Human Brain project

A global group of scientists are spending the next ten years and a billion dollars to try and develop a computer simulation of the brain: https://www.humanbrainproject.eu/ I always found it fascinating that the brain can understand itself. This almost sounds like in a few years the computer... (0 Replies)
Discussion started by: figaro
0 Replies

2. Ubuntu

Ubuntu 9.04 Serial application to telnet to serial device

Hello! I am working on an application which reads environmental instruments which have serial ports. The application requires a serial port to be present to talk to the device (i.e. /dev/ttyS0 ). In some instances the environmental devices will be 100's of yards away from the computer, so a... (5 Replies)
Discussion started by: mvona
5 Replies

3. Programming

Brain Teaser Extended

Hi Gurus, To the Brain Teaser, if I add another condition, say the executable should not be altered, how the program should be altered? (no perl please, purely C). I forgot to mention this condition my staff had mentioned. ( forgot then and got now :D ) The program executed the first time... (4 Replies)
Discussion started by: vrk1219
4 Replies

4. Programming

C Brain Teaser

Dear Gurus, I have encountered a C question, which I thought of sharing with you. This question was asked by one of my technical training staff...Though my training was over I'm still thinking of a solution for this.. Write a C program to do a small task(lets say just simply printing a "Hello... (34 Replies)
Discussion started by: vrk1219
34 Replies

5. Shell Programming and Scripting

Brain Bench Certification

Hi, Can anybody provide me Pointers to Practice tests or any Material to prepare for Brainbench certification in Unix Shell Scripting? Also how good is this Certification for UNIX programmers. Is it worth it? I'm planning to take this certification in 2 weeks. Kindly let me know all the pros... (0 Replies)
Discussion started by: pavan_emani
0 Replies
Login or Register to Ask a Question