SUN ULTRA 45 - Solaris


 
Thread Tools Search this Thread
Operating Systems Solaris SUN ULTRA 45 - Solaris
# 1  
Old 10-20-2009
SUN ULTRA 45 - Solaris

hi, my sun box hangs- KEYBOARD not found. Using hyper link it boots and then hangs without able to access or get ok promt
----SCREEN SHOT AS--------------------------------------------------
Code:
˙Loading onboard drivers: ebus i2c i2c i2c ppm
/ebus@1f,464000: flashprom rtc serial serial env-monitor i2c power
/ebus@1f,464000/i2c@3,80: gpio temperature temperature temperature front-io-fru-
prom sas-backplane-fru-prom dimm-spd psu-fru-prom hardware-monitor
/i2c@1f,520000: dimm-spd dimm-spd
/i2c@1f,530000: motherboard-fru-prom gpio clock-generator
/i2c@1f,462020: nvram idprom
Probing memory
CPU 0 Bank 2 base 200000000 size 1024 MB
NVRAM changes: 48b68
Probing I/O buses

System Reset: CPU Reset (SPOR)
Probing system devices
jbus at 0,0 SUNW,UltraSPARC-IIIi (1600 MHz @ 8:1, 1 MB) memory-controller
jbus at 1,0 Nothing there
jbus at 1c,0 Nothing there
jbus at 1d,0 Nothing there
jbus at 1e,0 pci
jbus at 1f,0 pci
Loading Support Packages: kbd-translator obp-tftp SUNW,i2c-ram-device SUNW,fru-d
evice SUNW,asr
Loading onboard drivers: ebus i2c i2c i2c ppm
/ebus@1f,464000: flashprom rtc serial serial env-monitor i2c power
/ebus@1f,464000/i2c@3,80: gpio temperature temperature temperature front-io-fru-
prom sas-backplane-fru-prom dimm-spd psu-fru-prom hardware-monitor
/i2c@1f,520000: dimm-spd dimm-spd
/i2c@1f,530000: motherboard-fru-prom gpio clock-generator
/i2c@1f,462020: nvram idprom
Probing memory
CPU 0 Bank 2 base 200000000 size 1024 MB
NVRAM changes: 48b68
Probing I/O buses


Sun Ultra 45 Workstation, No Keyboard
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
OpenBoot 4.25.9, 1024 MB memory installed, Serial #78653148.
Ethernet address 0:14:4f:b0:26:dc, Host ID: 84b026dc.



Boot device: disk File and args:
WARNING: msgsys:msginfo_msgtql is set more than once in /etc/system. "set msgsys
:msginfo_msgtql = 512" applied as the current setting.

WARNING: msgsys:msginfo_msgmax is set more than once in /etc/system. "set msgsys
:msginfo_msgmax = 8192" applied as the current setting.

WARNING: msgsys:msginfo_msgmnb is set more than once in /etc/system. "set msgsys
:msginfo_msgmnb = 262143" applied as the current setting.

WARNING: msgsys:msginfo_msgseg is set more than once in /etc/system. "set msgsys
:msginfo_msgseg = 768" applied as the current setting.

SunOS Release 5.10 Version Generic_118833-36 64-bit
Copyright 1983-2006 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
WARNING: Failed to install "beep" driver.
Hostname: SSS2


DO NOT ENTER USERNAME AND PASSWORD AT THE 'console login:' PROMPT
Unless you are booting to single user (maintenance) mode.

If you are not booting to single user mode, you will be logged in and
the GUI will start up automatically in a few moments. It may look like
nothing is happening, but I'm doing lots of important stuff. Really.


checking ufs filesystems
/dev/rdsk/c1t0d0s4: is logging.
Oct 16 17:03:57 SSS2 named[396]: zone 0.0.127.IN-ADDR.ARPA/IN: loading master fi
le db.127.0.0: unknown class/type

HANGS FOR HRS_______ANY ADVISE TO GET OK PROMT PLS

Last edited by pludi; 10-20-2009 at 07:45 AM.. Reason: code tags, please...
# 2  
Old 10-21-2009
Quote:
Originally Posted by mathav22
Sun Ultra 45 Workstation, No Keyboard
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
OpenBoot 4.25.9, 1024 MB memory installed, Serial #78653148.
Ethernet address 0:14:4f:b0:26:dc, Host ID: 84b026dc.
When you're about to see the above msg, use a Sun keyboard to press Stop+A or poweroff the system, remove the boot disk. The system will go to ok> prompt.
set the auto-boot option to false. poweroff system, insert your disk, then poweron.
# 3  
Old 10-22-2009
will try and let u know
Login or Register to Ask a Question

Previous Thread | Next Thread

10 More Discussions You Might Find Interesting

1. Solaris

Sun Ultra 5 new user

Hi I have just acquired an Ultra 5. It has 256MB of memory and a 360Mhz Ultra IIi SPARC processor. So far, I have had some typical fun and games to get it working: - It had a dead NVRAM chip. I hacked it open and installed a CR2032. It looks suitably bodged up, but is working. I set the MAC... (8 Replies)
Discussion started by: _JonB_
8 Replies

2. Solaris

Cannot install Sun Solaris 10 on Ultra 10

http://www.unix.com/images/smilies/mad.gif Hi, this is parameswar. I have two sun ultra 5/10 workstations processor is sparc IIi 440 and ram is 512 but without hard disk and cdrom so can i use seagate 40Gb and sony dvd writer which is presented in windows pc. Both are IDE cables. while I... (1 Reply)
Discussion started by: parameswar
1 Replies

3. Solaris

Sun Solaris Ultra 10 Not booting!

Hello I have Sun Ultra 10 with Solaris 7 installed on it. Sometimes back after that the machine use to get hang .Even after rebooting the system was not booting. I have manually switch on /off many times from the power board itself .Once in a while it use to boot .After... (12 Replies)
Discussion started by: turki_00
12 Replies

4. Solaris

hey i just got a Sun ultra 5!!!

now what do i do? im looking at it and i booted it after a bunch of code i got a line askign for the password i also downloaded solaris 10 any advice on how to install it? (36 Replies)
Discussion started by: russian460
36 Replies

5. Solaris

sun ultra

Hi Guys, I have a 2nd hand Sun ultra-5, I wanted to know how to be able to run it as a normal window. I do not have any experience whatsoever with solaris/unix. Does anyone can give me a clue where to start. When I switch it goes to: unix console login: pa$$word: #UNIX sendmail : enable to... (0 Replies)
Discussion started by: lingosa
0 Replies

6. Solaris

sun ultra or sun sparkstation

am wonder wich sun computer is better, a sun ultra or sun sparkstation, and what is the difference (7 Replies)
Discussion started by: nobody
7 Replies

7. UNIX Benchmarks

Sun Ultra 30 Solaris 8

Sun Ultra30 Solaris 8 Notes: ... Results: System -- SunOS box 5.8 Generic_108528-23 sun4u sparc SUNW,Ultra-30 Start Benchmark Run: Fri Sep 12 11:59:12 EDT 2003 1 interactive users. Dhrystone 2 without register variables 502087.7 lps (10 secs, 6 samples) Dhrystone 2 using... (2 Replies)
Discussion started by: tnorth
2 Replies

8. UNIX Benchmarks

Sun Ultra 2 Solaris 8

Sparc Ultra2: Notes prtdiag: System Configuration: Sun Microsystems sun4u Sun Ultra 2 UPA/SBus (2 X UltraSPARC-II 296MHz) System clock frequency: 99 MHz Memory size: 768 Megabytes ========================= CPUs ========================= Run Ecache CPU CPU... (0 Replies)
Discussion started by: tnorth
0 Replies

9. Filesystems, Disks and Memory

Tape Drive Connected to a Sun Ultra 10/Solaris 2.7

I have a Sun Ultra 10/Solaris 2.7 with a differential SCSI card connected to a Supter DLt1 Tape Drive. When I boot the machine, and I do a probe-scsi-all in the very beginning of the boot process. It shows up correctly. If I wait for the boot process to proceed and then I do a probe-scsi-all, I get... (1 Reply)
Discussion started by: brv
1 Replies

10. UNIX for Dummies Questions & Answers

Sun Ultra sparc 60

Hello everybody!! I need your help again. I am using Sun Ultra sparc 60 machine.Follwing are the types of files getting generated in /var/tmp. "windu_sm_o aaaa,baaa,caaa,daaa" etc. I am not able to locate which application is generating these files. Can I straightway delete these files ? or... (1 Reply)
Discussion started by: vikasdeshmukh
1 Replies
Login or Register to Ask a Question