Solaris

Hi all,

I just add in new cpu/memory module into SFV480 and unable to see new module on slot B. I already try many way like only 1 new module and swap the both module and boot up but still unable to see it.

If I only install the module into slot B, then the server is unbootable at all.

I already change one new centerplane but still the same.

The error show below.

Desired Safari Bus speed 150MHz, selecting 150MHz
Configuring CPUs..........
... CPU0 Rated Speed 900MHz, Safari 150MHz, want 6:1, got 6:1 ==> CPU 900MHz
Ecache 8MB 3.3ns mode=3-3-3 2-way ECCR: 0000.0000.0309.4400
... CPU2 Rated Speed 900MHz, Safari 150MHz, want 6:1, got 6:1 ==> CPU 900MHz
Ecache 8MB 3.3ns mode=3-3-3 2-way ECCR: 0000.0000.0309.4400 ...Done
Setting system speed (and resetting)...
<*>
Set Speed Reset

@(#)OBP 4.6.8 2002/09/04 13:45 Sun Fire 480R
Front Panel Keyswitch is in Diagnostic position.
Online: CPU0 Ultra-III+ (v2.2) 6:1 900MHz 8MB 3:1 ECache
Online: *CPU2 Ultra-III+ (v2.2) 6:1 900MHz 8MB 3:1 ECache
Executing Power On SelfTest w/%o0 = 0000.0000.0001.4042


0>Scan ring integrity
0>INFO: H/W under test = CPU Board Slot B (Cheetah 1, DCDS [0-7], SRAMs) Scan Ri
ng NOT Present or Shut OFF
0>INFO: H/W under test = CPU Board Slot B (Cheetah 3, SRAMs) Scan Ring NOT Prese
nt or Shut OFF

Already upgrade to latest OBP version.

Any idea pls help.

Thanks...

Its either you're not using the correct part OR its not secured properly on the slot, which may show this sort of errors or cause these..