i have a new netra 240 server when i make probe-scsi in obp i have this output :
ERROR: /pci@1c,600000: Last Trap: Fast Data Access MMU Miss
am upgarading obp firmware but the problem is always here
the os solaris 10) is installed correctely and i can use it , when i type #format i can see the scsi disk , but not in obp
and no fault in # prtdiag or post test
can you help me to resolve this problem ???
i'm trying to burn an DVD ISO into a VIOS virtual optical drive
when i try a scanbus i have a failure message :
Can u help me please guys
---------- Post updated at 03:38 PM ---------- Previous update was at 12:20 PM ----------
I can't burn in ISO format, so i have to type... (0 Replies)
Can anyone explain the output of probe-scsi command below?
ok probe-scsi
Target 0
Unit 0 Disk SEAGATE ST373207LSUN72G 045A
Target 1
Unit 0 Disk SEAGATE ST373207LSUN72G 045A
I have no idea what it means. I tried to read online but I still did not understand. I appreciate... (6 Replies)
HI
I have a V240 server and the probe-scsi-all on the Ok prompt is taking forever.
I have tried powercycling the server multiple times.
also tried set-defaults and reset-all..
COuld anyone tell the solution to this.. I have run out of options now.
Following is the only thing... (8 Replies)
Hi.
I need to boot on Sun Blade 150 from scsi-disk, that ran on old Sun Ultra 10.
It is necessary to take some the information from an old disk and something to study.
The workstation is booted and I receive the following issue::mad:
Sun Blade 150 (UltraSPARC-IIe 650MHz), No Keyboard (tip... (3 Replies)
Weird question I know, but I'm intrigued.
Say for instance you have an Application in an SG with the usual start/stop/monitor. To successfully probe does it just check for existence of the script/file ?
Thanks... (1 Reply)
I have run init 0 to bring it to OK prompt.
I know that probe-scsi-all can hang the system.
I want to know what is the difference between probe-scsi-all and probe-scsi.
I was told that probe-scsi-all external and internal devices and probe-scsi shows only internal devices. what dose this ... (3 Replies)
Hi folks,
I´m having a problem with a Ultra60 box with diff scsi pci card
conected to one D1000. The conection are correct because a checked the
D1000 guide. When a do probe-scsi-all in the OBP, the D1000 blink all
disks one time then the led of one of the disks powers off and then
nothing... (2 Replies)
When I am trying to read any tape I getthe following message on my screen:
"stp: Error on SCSI tape=0 (ha=0 id=6 lun=0)"
Does anybody know how to solve this problem and what the message means.
I already have rebooted the server and cleaned the heads of the tape unit.
HELP!!!! (1 Reply)
03-20-2009
???