8 More Discussions You Might Find Interesting
1. HP-UX
I have used ioscan -fnC tape and the system identified the tape drive. what is the command to show a listing of what is on the tape? I have used ls /dev/rmt/rmt0 to no avail. can anyone help?
Thanks in advance (10 Replies)
Discussion started by: Randydog
10 Replies
2. Solaris
Hi all,
this time I'd need a help from an advanced Solaris system admin :rolleyes:
I attached a HP StorageWorks Ultrium 215 Tape Drives - Overview - c00059530 - HP Business Support Center to my Sun E220R and it got recognized immediately (probe-scsi-all).
Now the operating system boot process... (8 Replies)
Discussion started by: pseudocoder
8 Replies
3. AIX
I have a p570 running AIX 5.2 ml 10. We just got in a IBM 3582 library. The library is connected directly to the lpar via fibre cable.
I've installed:
Atape.driver 11.7.7.0
atldd.driver 6.8.4.0
After a reboot, I can see the one tape drive:
... (2 Replies)
Discussion started by: BobSmith
2 Replies
4. Solaris
Hi everyone.
Im new to Sun Solaris or the Unix environment. My only background is the DOS command in windows and a little bit of c++ programming. I always worked with troubleshooting hardware and software issues with windows.
Now that I need to configure tape drives using sun solaris, I had... (11 Replies)
Discussion started by: graboid888
11 Replies
5. AIX
I have tape drive in one Lpar. when i saw that time tape is in defined state. After that i deleted the tape drive using the rmdev -R command. Then fired the cfgmgr -v command. But I am not getting the tape drive. Now the drive is even not in defined state also. It is not shown the tape drive. How... (1 Reply)
Discussion started by: pernasivam
1 Replies
6. AIX
Hey anyone have the hot news on where to find out if This tape will work with my AIX 5.3?
a Dell PV110T ~ AIX
Base Unit:
PV110T,LTO-3,400/800GB,EXT PowerVault 110T, LTO-3 400/800GB, External Drive-R (222-2100)
Hard Drive Controller:
External 4M SCSI Cable VHDCI/68 pin for Tape... (0 Replies)
Discussion started by: Keith Johnson
0 Replies
7. UNIX for Dummies Questions & Answers
Hi,
I need to restore my tape backup, when I type "tape status" it gives;
status : ready beginning-of-tape write-protected
soft errors : 0
hard errors : 0
underruns : 3
but... (4 Replies)
Discussion started by: alisevA3
4 Replies
8. UNIX for Advanced & Expert Users
I am trying to configure DAT Tape drive on SUN E220 system but I don't have SUN keyboard. I am using a tty terminal k/b.
What are my alternavtives?
Is there any way to send interupts to the system on OK prompt using tty kb for probe SCSI.
Thanks in advance. (2 Replies)
Discussion started by: s_aamir
2 Replies