Hi all, i have a problem with (Network in Linux) .. my issue with a HW appliance has openfiler 2.3 and is used for File Sharing using samba .. the problem is when i try to list all configured network interfaces using ifconfig -a .. i can't see the loopback interface, Although the file /etc/sysconfig/network/ifcfg-lo exist and here is it's content
I have tried ifdown and ifup lo .. ddn't work
I have also tried to service netwrok stop/start .. didn't work
I have tried /etc/init.d/network stop/start .. bad news too
Here is the output of hosts file
Any recommendation will by appreciated.
Last edited by DukeNuke2; 03-18-2012 at 06:12 PM..
clear
echo "vans, Rolland"
echo "Press in Your Keyboard to Quit"
echo -e "Please Enter Your Choice : \c"
read option
case $option in
I have created the corresponding information for each input on the display so...
My question is...
How do I display the corresponding information... (6 Replies)
This is in the beginning of the program:
clear
tput cup 1 20
echo "Welcome to UNIX I Final Assignment"
tput cup 4 3
echo -e "Who would you like to look up? \c"
tput cup 6 5
echo "vans, Rolland"
tput cup 8 5
echo "ones, Mildred"
tput cup 10 5
echo "mith, Julie"
tput cup 12 5
echo... (0 Replies)
Hi,
I am looking for an awk script which should help me to meet the following requirement:
File1 has records in following format
INF: FAILEd RECORD AB1234
INF: FAILEd RECORD PQ1145
INF: FAILEd RECORD AB3215
INF: FAILEd RECORD AB6114
............................ (2 Replies)
Hi all
I have installed a demo version of SCO OpenServer 5.0.2, I finally found it is Desktop Interface, I would like to know how to change its interface to dos based interface?
If you have any ideas, please tell me then. Thank you (2 Replies)
Dear all,
I am a newbie in solaris and I need your advice.
I have a Solaris version 5.9 installed on Sunfire V240.
I am able to ssh the machine from putty remotely.
My problem is that I cannot see the display from KVM switch I have connected to it. I need also to be able to see the GUI... (2 Replies)
Hi All,
I need to configure a floating IP on loopback interface of two servers (RHEL 5.4). After configuring, I'm not able to ping to that IP from a different server.
I fail to understand what is missing here. I have done similar configuration in another environment & it works fine.
Plz help.... (0 Replies)
Hello,
I have a SunOS (5.5.1) system that I need to migrate to a new IP address. I would like to have any requests destined for the old IP to be forwarded to this server.
One suggestion I had was to add a route on my router that would point the old IP to the new IP.
How do I add another... (2 Replies)
Hey guys...
I'm learning some shell scripting on OS X using the tcsh shell.
For some reason... my while loop isn't executing right (or more likely I am doing something wrong.)
Something as simple as this doesn't work:
#!/bin/tcsh
set g = 0
while ($g <10)
echo "this" $g
@ g =... (2 Replies)
Recently I noticed that my internet connection would not work correctly-although connected domain names could not be resolved. My resolv.conf file was fine since it is configured every time I dial up. a closer inspection showed that my loopback interface had disappearerd! Any ideas why would this... (1 Reply)