SCO

Hello Dears,
I have fujitsu tx300 S7 server with installed sco unixware 7.1.4,
Now the /etc is corrupted and the sco cannot boot.
There is no emergency disk or cd, I'm trying to fix this with reinstalling unixware again, but the problem now that when i try to install the HBA driver that i already have its driver that was installed befre , error msg appeared that ( cannot mount the HBA media.
Any help fot that or any help to let me recover the corrupted /etc ??

I can't read your attachments on my phone, but i believe your hd has failed.

Errors on /ets and unix cannot load, any help ?

What does the LSI firmware say about the condition of the drive(s)?
Is there only a single disk or is it a RAID system?

when i try to boot from sco unixware 7.1.4 CD and try to install my LSA SAS driver (error cannot mount the Hba Driver)as attached, and this is the same driver i installed it before and i'm sure that it is the correct LSA driver.
i have 3 H.Ds 2*600 RAID1 + 1*600 RAID0 (as attached).
there is no emergency disk so there is anyway to access the unis file system and restore the corrupted /etc ?? ,
any idea why the HBA Driver cannot mount ? specially i think that when i go to HBA driver to load the server not looking for any driver then the error msg appears

Is the HBA driver on a diskette, or CD? The media could simply be corrupt. The message seems to indicate that the media the driver is on is the problem.
Have you run the WebBIOS to confirm the condition of the RAID?

the media is not corrupted i used CD and usb floppy and USB flash ,i have the driver and i already downloaded it again but the same error msg,i think the problem is not the device or the media !!
there is any otherway to repair the corupted /etc ?
the RAID configuration is working good i checked it