10 More Discussions You Might Find Interesting
My desired output is
for this 1
for this 2
for this 3
for this 4
for this 5
for this 1,2
for this 2,3
for this 3,4
for this 4,5
for this 1,2,3
1->2,3 (2 Replies)
Discussion started by: vaibhavkorde
genunix: NOTICE: ce0: xcvr addr:0x01 - link up 100 Mbps half duplex
genunix: WARNING: ce0: fault detected external to device; service degraded
genunix: WARNING: ce0: xcvr addr:0x01 - link down
genunix: NOTICE: ce0: fault cleared external to device; service available
genunix: ... (4 Replies)
Discussion started by: sunnybee
i have replace a NIC card on solaris 10 when i give the following command
it just show the lo0 (only loop back with inet 127.0.0.1)
when i give the following command to config the interface,
ifconfig elxl0 plumb
ifconfig: plumb: elxl0: no such interface
please help... (11 Replies)
Discussion started by: malikshahid85
Hi, i have problems with an installation of Debian i386 505 in a pc. The hardware it is a mother soyo with a chipset via.
When i install the xorg, the installation it`s succesfull, but when i type startx, the pc don`t respond.
I am from Argentina and my English it isn`t good. Sorry. (0 Replies)
Discussion started by: Kritar
Hello, I'm trying to use libcurl multi interface to fetch several data in parallel. I would expect this to be faster than performing repeated fetches using the easy interface, but for some reason I can't obtain any speed up at all: using the multi interface actually turns out to be MUCH slower than... (2 Replies)
Discussion started by: clalfa
im trying to install Java in Debian lenny with apt-get install but can find the packages...anyone can help me on this one?
thanks (2 Replies)
Discussion started by: ro0t3d
7. UNIX for Advanced & Expert Users
i have problem with my box,
until now i can't investigate the root cause of my issue at my box.
here the problem.
i have a box as a squid server just forward all request packet from one interface and receive the packet then forward to client at the same interface. but after 5 hours i... (1 Reply)
Discussion started by: tindasz
tried to native compile Debian Dialog as ncurses-dev is available.
I am trying native compile Debian Dialog using gcc on Linux embedded router.
What's wrong, as running than make
I get errors.
Mayby this line in the log file is an exaplanation to a problem ?
checking if we have... (1 Reply)
Discussion started by: jack2
Hi every body,
I have a Fiber Channel interface (fcs2) in AIX 5.2. This interface was fine & up but for some reason I could not return this interface UP again after I set it DOWN.
When I tried to set this interface UP I encountered the following error:
Method error... (7 Replies)
Discussion started by: aldowsary
10. UNIX for Advanced & Expert Users
Need some help on network interface issue..
I have added 2 x NIC card onto the Ultra 2 system recently and configured as hme1 and hme2. I have unconfigured the onboard hme0 network interface and it was running fine till few days later, i keep recieving error messages showing hme0... (6 Replies)
Discussion started by: sc2005