xfree86 man page for fs_getcrypt

FS_GETCRYPT(1)						       AFS Command Reference						    FS_GETCRYPT(1)

NAME
       fs_getcrypt - Displays the state of encryption for AFS file transfers

SYNOPSIS
       fs getcrypt [-help]

DESCRIPTION
       The fs getcrypt command shows the status of network traffic encryption for file traffic in the AFS client. This encryption applies to file
       traffic going to and coming from the AFS server for users with valid tokens. The complement of this command is fs setcrypt which sets the
       status of encryption on the client.

CAUTIONS
       AFS uses an encryption scheme called fcrypt, based on but slightly weaker than DES. Because fcrypt and DES are obsolete, the user must
       decide how much to trust the encryption. Consider using a Virtual Private Network at the IP level if better encryption is needed.

       Encrypting file traffic requires a token. Unauthenticated connections or connections authorized via IP-based ACLs will not be encrypted
       even when encryption is turned on.

OPTIONS
       -help
	   Prints the online help for this command. All other valid options are ignored.

OUTPUT
       If encryption is enabled, the output is:

	  Security level is currently crypt (data security).

       If encryption if disabled, the output is:

	  Security level is currently clear.

EXAMPLES
       There is only one way to invoke fs getcrypt:

	  % fs getcrypt

PRIVILEGE REQUIRED
       No special priviledges are required for this command.

SEE ALSO
       fs_setcrypt(1)

       The description of the fcrypt encryption mechanism at http://surfvi.com/~ota/fcrypt-paper.txt <http://surfvi.com/~ota/fcrypt-paper.txt>.

COPYRIGHT
       Copyright 2007 Jason Edgecombe <jason@rampaginggeek.com>

       This documentation is covered by the BSD License as written in the doc/LICENSE file. This man page was written by Jason Edgecombe for
       OpenAFS.

OpenAFS 							    2012-03-26							    FS_GETCRYPT(1)