sys_attrs_netrain(5) File Formats Manual sys_attrs_netrain(5)
NAME
sys_attrs_netrain - netrain subsystem attributes
DESCRIPTION
This reference page lists and describes attributes for the Redundant Array of Independent Network adapters (NetRAIN) (netrain) kernel sub-
system. Refer to the sys_attrs(5) reference page for an introduction to the topic of kernel subsystem attributes.
A value that enables (1) or disables (0) the logging of NetRAIN debug messages in syslog kern.log file.
Do not modify the default setting for this attribute unless instructed to do so by Compaq Computer Corporation support personnel or
by patch kit documentation.
Default value: 0 (disabled)
The number of NetRAIN devices allowed on the system. The first NetRAIN device is nr0.
Default value: 128 (devices)
Minimum value: 0
Maximum value: 512
The maximum nr device number is nr_maxdev - 1. For example, using the default value of 128, the maximum NetRAIN device number is
nr127.
The time interval or frequency between successive polls of a dead interface by the Network Interface Failure Finder (NIFF) traffic
monitor thread (nifftmt).
Default value: 6 (seconds)
Minimum value: 0
Maximum value: INT_MAX, or 2 billion
The total amount of time for the nifftmt thread routine to declare an interface dead (from the GREEN state to the DEAD state).
Default value: 10 (seconds)
Minimum value: 0
Maximum value: INT_MAX, or 2 billion
The time interval or frequency between successive reads of a NetRAIN interface's counters by the nifftmt thread when the network is
operating normally.
Default value: 4 (seconds)
Minimum value: 0
Maximum value: INT_MAX, or 2 billion
SEE ALSO
sys_attrs(5)
Network Administration
sys_attrs_netrain(5)
