netbsd man page for ldpd

LDPD(8) 						    BSD System Manager's Manual 						   LDPD(8)

NAME
     ldpd -- Label Distribution Protocol Daemon

SYNOPSIS
     ldpd [-DdfhW] [-c config_file] [-p port]

DESCRIPTION
     ldpd is a utility used to automatically distribute labels between two MPLS LSRs almost conforming to RFC3036.  Right now it is in BETA stage
     and many features are not implemented or may not work.  As a security measure you SHOULD filter the LDP well-known (646) TCP and UDP ports
     using your favourite packet filter before starting ldpd.  Also this is the current measure used to filter neighbours.  You should see some
     logs reported via syslog(3) interface.

     You can increase the log verbosity using the -W and -D flags.  Also you can telnet to the control port (default: 2626) and use this interface
     in order to get informations about protocol, neighbours etc. but also to set runtime parameters.  The required password is the same as the
     root password.

     ldpd computes existing routes and tries to match them on MPLS labels announced by other LDP peers.  This means that ``normal'' routes will be
     changed into tagged routes, and MPLS routing table will be populated.  It will also announce its mappings to its peers.  ldpd will listen on
     a route socket and compute the necessary changes in order to change untagged routes into tagged routes.  This means that one may use one's
     favourite dynamic routing protocol daemon without modifications.

     The options are as follows:

     -c config_file   Specifies a path to the config file.  Default: /etc/ldpd.conf - see ldpd.conf(5) for configuration file format.

     -D 	      Enable debug mode.

     -d 	      Don't use route interception code.

     -f 	      Run in foreground.  Use STDOUT for warning and debug messages.

     -h 	      Outputs supported flags.

     -p port	      Changes the TCP control port (default: 2626).

     -W 	      Enable output of warning messages.

SEE ALSO
     LDP Specification, RFC, 3036, January 2001.

     LDP Applicability, RFC, 3037, January 2001.

HISTORY
     The ldpd command appeared in NetBSD 6.0.

BUGS
     ldpd supports only IPv4 and doesn't implement Path Vector and Hop Count TLVs.

BSD
								   July 7, 2011 							       BSD