netbsd man page for iscsid

ISCSID(8)						    BSD System Manager's Manual 						 ISCSID(8)

NAME
     iscsid -- interface to kernel iSCSI driver

SYNOPSIS
     iscsid [-n] [-d lvl]

DESCRIPTION
     The iSCSI initiator runs as a kernel driver, and provides access to iSCSI targets running across a network using the iSCSI protocol, RFC
     3720.  The iscsid utility itself interfaces to the kernel iSCSI driver, and also communicates, using isns(3), with the iSCSI name service
     running on other hosts to locate services and iSCSI instances.  In normal operation, iscsid is a standard daemon, and will detach from the
     controlling terminal using daemon(3) and then loops, reading requests, processing them, and sending responses.  Communication takes place
     over a Unix domain socket.  iscsid exits on receiving a terminate message, (no response to one that is sent to the kernel), or when an error
     occurs reading from or writing to the socket.

     The -d flag increases the debug level to lvl.  Any level above 0 causes iscsid to remain in the foreground, and increases the amount of debug
     output.  The -n flag makes the daemon single-threaded.

     It is envisaged that user-level communication take place with iscsid using the iscsictl(8) utility, rather than directly over its communica-
     tion socket.  An example of setting up the in-kernel iSCSI initiator is shown in iscsictl(8).

SEE ALSO
     daemon(3), isns(3), iscsictl(8)

HISTORY
     The iscsid utility appeared in NetBSD 6.0.

AUTHORS
     Alistair Crooks <agc@NetBSD.org> wrote this manual page.  The iscsid utility was contributed by Wasabi Systems, Inc.

BSD
								   May 27, 2012 							       BSD