minix man page for fwe

FWE(4)							   BSD Kernel Interfaces Manual 						    FWE(4)

NAME
     fwe -- Ethernet emulation driver for FireWire

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device firewire
	   device fwe

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   if_fwe_load="YES"

DESCRIPTION
     The fwe driver provides non-standard Ethernet emulation over FireWire (IEEE 1394).

     firewire(4) and fwohci(4) must be configured in the kernel as well.

     This driver exploits asynchronous stream over IEEE 1394 to carry Ethernet frames.	The stream channel can be specified by the
     hw.firewire.fwe.stream_ch sysctl(8).

     This driver supports polling(4) as well if it is compiled with the DEVICE_POLLING option.

SEE ALSO
     arp(4), firewire(4), fwip(4), fwohci(4), netintro(4), ng_ether(4), polling(4), ifconfig(8), kldload(8), sysctl(8)

HISTORY
     The fwe device driver first appeared in FreeBSD 5.0.

AUTHORS
     The fwe driver and this manual page were written by Hidetoshi Shimokawa.

BUGS
     This driver emulates Ethernet in a very adhoc way and it does not reserve a stream channel using an isochronous manager.  Note that this
     driver uses a protocol which is very different from RFC 2734 (IPv4 over IEEE 1394).

BSD
								   July 16, 2005							       BSD