linux man page for idt

IDT(4)                                                     BSD Kernel Interfaces Manual                                                     IDT(4)

NAME
     idt -- device driver for IDT NICStAR-based ATM interfaces

SYNOPSIS
     device idt
     device atm

DESCRIPTION
     The idt device driver supports ATM network interfaces based on the IDT NICStAR 77211 controller, including the FORE Systems ForeRunner LE25
     and LE155.  For configuring the card for IP see natmip(4).

     ATM CBR connections are supported, and bandwidth is allocated in slots of 64k each.  Three VBR queues handle traffic for VBR and UBR.  Two
     UBR queues prioritize UBR traffic.  ILMI and signalling get the higher priority queue, as well as UBR traffic that specifies a peak cell
     rate.  All other UBR traffic goes into the lower queue.

     The following sysctls are recognized by the driver:

     hw.idt.log_bufstat
             Print statistics about buffer use to the system log periodically.

     hw.idt.log_vcs
             Print information about VC opens, closes, and other events to the system log.

     hw.idt.bufs_large
             Set or print the maximum size of the 2KB buffer queue.

     hw.idt.bufs_small
             Set or print the maximum size of the mbuf queue.

     hw.idt.cur_large
             Print the current size of the 2KB buffer queue.

     hw.idt.cur_small
             Print the current size of the mbuf queue.

     hw.idt.qptr_hold
             Optimize the TX queue buffer for lowest overhead.

SEE ALSO
     natm(4), natmip(4), ifconfig(8), route(8)

AUTHORS
     Richard Hodges, based on the original driver for FreeBSD 2.2 by Mark Tinguely.  Bruce M. Simpson wrote this manual page and backported the
     driver to FreeBSD 4.9.

BSD                                                                June 3, 2003                                                                BSD