hpux man page for rarpc

rarpc(1M)																 rarpc(1M)

NAME
       rarpc - Reverse Address Resolution Protocol client

SYNOPSIS
       count] interface_name

DESCRIPTION
       the Reverse Address Resolution Protocol client, implements the client portion of the Reverse Address Resolution Protocol (see It sends RARP
       requests for the specified interface's hardware address and waits for the response from the RARP server.  can be used during boot-time ini-
       tialization to find the IP address of an interface.  To do so, set the i] variable of interface i with in

       Options are:

	      Print debugging information.

	      Use ethernet encapsulation only.

	      Use SNAP encapsulation only.

	      Transmits count requests and waits for each one to time out before
			       giving up.

	      interface_name   Identifies the interface to request information about.

       If  a  response	is  received, it prints the IP address to its standard output.	This information can be used to configure the interface as
       seen in

       If a response is not received, the client will retransmit after 2 seconds, and then after 4 seconds.   After  that,  retransmissions  occur
       every 8 seconds.

RETURN VALUE
       Exit  status  is 1 if the command fails or no RARP response is received.  Exit status is 0 and the IP address is printed to standard output
       if a response is received.

LIMITATIONS
       1. The client cannot be run at the same time a daemon is running on the same interface.

       2. The client supports only ethernet, 100VG and FDDI network interfaces.

AUTHOR
       was developed by HP.

SEE ALSO
       rarpd(1M).

       R. Finlayson, T. Mann, J.C. Mogul, M. Theimer, "Reverse Address Resolution Protocol", RFC 903.

																	 rarpc(1M)