debian man page for sg_rtpg

SG_RTPG(8)							     SG3_UTILS								SG_RTPG(8)

NAME
       sg_rtpg - sends a SCSI REPORT TARGET PORT GROUPS command

SYNOPSIS
       sg_rtpg [--decode] [--help] [--hex] [--raw] [--verbose] [--version] DEVICE

DESCRIPTION
       Send a SCSI REPORT TARGET PORT GROUPS command to DEVICE and outputs the response.

       Target  port  group  access  is described in SPC-3 found at www.t10.org in section 5.8 (in rev 21c dated 2005/1/15). The Report Target Port
       Groups command is also described in that document.

OPTIONS
       Arguments to long options are mandatory for short options as well.

       -d, --decode
	      decodes the status code and asymmetric access state from each target port group descriptor returned. The default action  is  not	to
	      decode these values.

       -h, --help
	      output the usage message then exit.

       -H, --hex
	      output response in hex (rather than partially or fully decode it).

       -r, --raw
	      output response in binary to stdout.

       -v, --verbose
	      increase the level of verbosity, (i.e. debug output).

       -V, --version
	      print the version string and then exit.

NOTES
       The  Report  Target  Port  Groups  command should be supported whenever the TPGS bits in a standard INQUIRY response are greater than zero.
       [View with sg_inq utility.]

EXIT STATUS
       The exit status of sg_rtpg is 0 when it is successful. Otherwise see the sg3_utils(8) man page.

AUTHORS
       Written by Douglas Gilbert.

REPORTING BUGS
       Report bugs to <dgilbert at interlog dot com>.

COPYRIGHT
       Copyright (C) 2004-2007 Christophe Varoqui and Douglas Gilbert
       This software is distributed under a FreeBSD license. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A  PARTICULAR  PUR-
       POSE.

SEE ALSO
       sg_inq(sg3_utils)

sg3_utils-1.23							   January 2007 							SG_RTPG(8)