debian man page for myson-diag

MYSON-DIAG(8)						      System Manager's Manual						     MYSON-DIAG(8)

NAME
       myson-diag - EEPROM setup and diagnostic program for ethernet cards based on the Myson MTD803 chip.

SYNOPSIS
       myson-diag [options]

DESCRIPTION
       myson-diag is a program that you can use to diagnose problems with ethernet cards based on the Myson MTD803 chip.

OPTIONS
       These  programs	follow	the  usual  GNU  command  line	syntax, with long options starting with two dashes (`-').  A summary of options is
       included below.

       -h, --help
	      Show summary of options.

       -V, --version
	      Show version of program.

       -v, --verbose
	      Verbose mode.

       -q, --quiet
	      Be very unverbose.

       -# <cardnum>
	      Use card number <cardnum>.

       -a, --show_all_registers
	      Print all registers.

       -e, --show-eeprom
	      Dump EEPROM contents to stdout.

       -E, --emergency-rewrite
	      Re-write a corrupted EEPROM.

       -p, --port-base <port>
	      Specify port to use.

       -A, --Advertise <mediaype>
	      Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.

       -F, --new-interface <interface>
	      Interface number. Options that make sense are: 10baseT, 10base2, AUI, 100baseTx, 10baseT-FDX, 100baseTx-FDX,  100baseT4,	100baseFx,
	      100baseFx-FDX, MII and Autosense.

       -H, --new-hwaddress <address>
	      Set card to a new hardware address.

       -m, --show-mii
	      Dump MII management registers.

       -R, --reset
	      Reset the transceiver.

       -T, --test
	      Do register and SRAM test.

       -w, --write-EEPROM <values>
	      Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!

       -f, --force-detection
	      Try to identify the card, even if it is active.

       -t, --chip-type <card>
	      Explicitly set the chip. To get all valid numbers, run myson-diag with the options '-t -1'.

SEE ALSO
       mii-diag(8)

AUTHOR
       myson-diag  was	written  and  is  still  maintained  by Donald Becker <becker@scyld.com>.  This manual page was written by Alain Schroeder
       <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).

								 February 18, 2002						     MYSON-DIAG(8)