debian man page for eepro100-diag

Query: eepro100-diag

OS: debian

Section: 8

Format: Original Unix Latex Style Formatted with HTML and a Horizontal Scroll Bar

EEPRO100-DIAG(8)					      System Manager's Manual						  EEPRO100-DIAG(8)

NAME
eepro100-diag - EEPROM setup and diagnostic program for Intel EtherExpress Pro100B, and EEPro PCI 10+ ethernet cards.
SYNOPSIS
eepro100-diag [options]
DESCRIPTION
eepro100-diag is a program that you can use to diagnose problems with ethernet cards based the "Speedo3" chip series: the i82557, '558 and '559. These chips are used on the EtherExpress Pro100B, and EEPro PCI 10+.
OPTIONS
These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below. -h, --help Show summary of options. -V, --version Show version of program. -v, --verbose Verbose mode. -q, --quiet Be very unverbose. -# <cardnum>, --card_num <cardnum> Use card number <cardnum>. -a, --show_all_registers Print all registers. -e, --show-eeprom Dump EEPROM contents to stdout. -E, --emergency-rewrite Re-write a corrupted EEPROM. -p, --port-base <port> Specify port to use. -A, --Advertise <mediaype> Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD. -F, --new-interface <interface> Interface number. Options that make sense are: 10baseT, 10base2, AUI, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII and Autosense. -H, --new-hwaddress <address> Set card to a new hardware address. -m, --show-mii Dump MII management registers. -R, --reset Reset the transceiver. -T, --test Do register and SRAM test. -w, --write-EEPROM <values> Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do! -f, --force-detection Try to identify the card, even if it is active. -t, --chip-type <card> Explicitly set the chip. To get all valid numbers, run eepro100-diag with the options '-t -1'.
SEE ALSO
mii-diag(8)
AUTHOR
eepro100-diag was written and is still maintained by Donald Becker <becker@scyld.com>. This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others). February 18, 2002 EEPRO100-DIAG(8)
Related Man Pages
eepro100-diag(8) - debian
epic-diag(8) - debian
natsemi-diag(8) - debian
ne2k-pci-diag(8) - debian
rtl8139-diag(8) - debian
Similar Topics in the Unix Linux Community
NIC Driver
determining ethernet port speed in solaris
Add PCI ethernet card?
ethernet card
How to Advertise on The Unix and Linux Forums