debian man page for oss_digi96

oss_digi96(7)							    OSS Devices 						     oss_digi96(7)

NAME
       oss_digi96 - RME Digi96 professional audio driver.

DESCRIPTION
       Audio driver for the RME Digi96 family of profressional audio controllers.

       o  Only 16 and 24/32 bit audio formats are supported.

       o  All Digi96 family members support 32kHz, 44.1kHz, 48kHz, 64kHz, 88.2kHz and 96kHz. sampling rates.

MIXER PANEL
       Note! For recording you need to set digi96.sync to INTERNAL and the values of digi96.mode and digi96.input to match your studio setup. Oth-
       erwise recordings will fail with I/O error.

       There are several settings that can be changed using the ossmix program shipped with OSS. Note that  some  features  don't  work  with  all
       Digi96 family members. For example ADAT mode is not supported by the base model.

       o  digi96.mode  <SPDIF|AESEBU|ADAT>:  This setting controls the output mode which can be S/PDIF (consumer), AES/EBU (professional) or ADAT.
	  The input mode is detected automatically.  If ADAT input is detected the output mode	will  be  switched  to	ADAT  automatically  (this
	  doesn't work in the other direction).

       o  digi96.sync <EXTERNAL|INTERNAL>: This setting tells if the playback sampling rate is based on the internal oscillator or the sample rate
	  detected in the input port. See also the definition of the digi96.worldclk setting.

       o  digi96.input <OPTICAL|COAXIAL|INTERNAL|XLR>: Selects the active input.

       o  digi96.sel <BYPASS|NORMAL>: When set to BYPASS the input signal will be routed directly to the output (also sets  digi96.sync  automati-
	  cally to EXTERNAL). In this mode audio data written to /dev/dsp will be muted.

       o  digi96.worldclk  ON|OFF:  Setting  this control to ON will enable the optional worldclock input as the sample rate source (overrides the
	  digi96.sync setting).

       o  digi96.emph ON|OFF: Enables/disables the de-emphasis option on the analog (monitor) output connector.

       o  digi96.data <AUDIO|AC3>: Specifies if the output signal is audio or AC3 data (sets the non-audio bit in the channel status data).

OPTIONS
       None

FILES
       /etc/oss4/conf/oss_digi96.conf Device configuration file

AUTHOR
       4Front Technologies

								 16 December 2012						     oss_digi96(7)