bsd man page for sri

SRI(4)							     Kernel Interfaces Manual							    SRI(4)

NAME
       sri - DR11-C IMP interface

SYNOPSIS
       /sys/conf/SYSTEM:
	    NSRI sri_controllers     # SRI DR11c ARPAnet IMP

DESCRIPTION
DIAGNOSTICS
       sri%d: not alive.  The initialization routine was entered even though the device did not autoconfigure.	This indicates a system problem.

       sri%d:  can't  initialize.  Insufficient UNIBUS resources existed to initialize the device.  This is likely to occur when the device is run
       on a buffered data path on an 11/750 and other network interfaces are also configured to use buffered data paths, or when it is	configured
       to use buffered data paths on an 11/730 (which has none).

       sri%d: imp doesn't respond, ibf=%b.  The driver attempted to initialize the device, but the IMP failed to respond after 5 tries.  Check the
       cabling.

       sri%d: stray xmit interrupt, csr=%b.  An interrupt occurred when no output had previously been started.

       sri%d: output error, csr=%b.  The device indicated a problem sending data on output.

       sri%d: input error, ibf=%b.  The device indicated a problem receiving data on input.

       sri%d: bad length=%d.  An input operation resulted in a data transfer of less than 10 or more than 1008 bytes of data into memory  (accord-
       ing to the word count register).  This should never happen as the maximum size of a host-IMP message is 1018 bytes.

3rd Berkeley Distribution					  August 20, 1987							    SRI(4)