opendarwin man page for richcomm_usb

RICHCOMM_USB(8) 						    NUT Manual							   RICHCOMM_USB(8)

NAME
       richcomm_usb - Driver UPS equipment using Richcomm dry-contact to USB solution

NOTE
       This man page only documents the specific features of the richcomm_usb driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE
       The Richcomm dry-contact to USB solution is a generic interface that is used to upgrade an existing (RS-232) contact closure UPS interface
       to USB. As such, all the limitations of the underlying contact closure interface apply. This means that you will only get the essentials in
       ups.status: OL, OB, and LB. See also genericups(8).

BUGS
       Most contact-closure UPSes will not power down the load if the line power is present. This can create a race when using slave upsmon(8)
       systems. See the upsmon(8) man page for more information.

       The solution to both of these problems is to upgrade to a smart protocol UPS of some kind that allows detection and proper load cycling on
       command.

AUTHORS
       Peter van Valderen <p.v.valderen at probu.nl>, Dirk Teurlings <dirk at upexia.nl>

SEE ALSO
   The core driver:
       nutupsdrv(8)

   The generic serial driver:
       genericups(8)

   Internet resources:
       The NUT (Network UPS Tools) home page: http://www.networkupstools.org/

Network UPS Tools						    05/21/2012							   RICHCOMM_USB(8)