osf1 man page for rc2

rc2(8)							      System Manager's Manual							    rc2(8)

NAME
       rc2 - Run command script executed when entering a multiuser run level

SYNOPSIS
       rc2

DESCRIPTION
       The  rc2  script contains run commands that enable initialization of the system to a multiuser state; run level 2.  In addition to commands
       listed within the script itself, rc2 contains instructions to run certain commands found in the /sbin/rc2.d directory.  The script  defines
       the conditions under which the commands execute; some commands run if the system is booting, other commands execute if the system is chang-
       ing run levels.

       By convention, files in the /sbin/rc2.d directory begin with either the letter "K" or the letter "S" and are followed by a two-digit number
       and a filename; for example: K00lpd     S00savecore     S25uucp

       In  general,  the  system  starts commands that begin with the letter "S" and stops commands that begin with the letter "K."  Commands that
       begin with the letter "K" run only when the system is changing run levels from a higher to a lower level.  Commands  that  begin  with  the
       letter "S" run in all cases.  The numbering of commands in the /sbin/rc2.d directory is important since the numbers are sorted and the com-
       mands are run in ascending order.  Files in the /sbin/rc2.d directory are normally links to files in the /etc/init.d directory.

       An entry in the inittab file causes the system to execute the  rc2  run	commands,  for	example:  s2:23:wait:/sbin/rc2	<  /dev/console  >
       /dev/console 2>&1

       The  following operations are typical of those that result from executing the rc2 script and the commands located in the /sbin/rc2.d direc-
       tory.  The operation depends on which state the system is entering or exiting.  Setting the time zone Checking the current run level  Stop-
       ping  network  services	and daemons Starting (or stopping) system services and daemons Starting the cron daemon Setting up paging and dump
       facilities Setting up uucp files

       Setting the TIMEZONE variable is one of the first operations completed by the rc2 script.  This action provides the default time  zone  for
       subsequent commands.

FILES
       Specifies the command path Specifies the directory of commands that correspond to the run level

RELATED INFORMATION
       Commands:  init(8), rc0(8), rc3(8) delim off

																	    rc2(8)