freebsd man page for lptcontrol

LPTCONTROL(8)						    BSD System Manager's Manual 					     LPTCONTROL(8)

NAME
     lptcontrol -- a utility for manipulating the lpt printer driver

SYNOPSIS
     lptcontrol -e | -i | -p | -s [-d control_device]

DESCRIPTION
     The lptcontrol utility is used to set either the interrupt-driven, extended, standard, or polling mode of individual lpt(4) devices.  When a
     printer is switched from a mode to another, this change will only take effect the next time the device is opened.

     Extended mode is anything the parallel port interface can support.  For an ECP/ISA parallel port, it may be FIFO+DMA or ECP.

     The following command line options are supported:

     -e      Turn on extended mode.

     -i      Turn on interrupt-driven mode.

     -p      Turn on polled mode.

     -s      Turn on standard mode, i.e., turn off extended mode.

     -d control_device
	     Set the mode of the printer control device specified by control_device.  The default value for control_device is /dev/lpt0.ctl.

     One of -e, -i, -p or -s must be specified.

FILES
     /dev/lpt?		     printer devices
     /dev/lpt?.ctl	     printer control devices
     /sys/i386/conf/GENERIC  kernel configuration file
     /boot/device.hints      device hints for the parallel port chipset driver, ppc(4)

SEE ALSO
     lpt(4), ppc(4), device.hints(5)

HISTORY
     The lptcontrol utility first appeared in FreeBSD 1.1.5

AUTHORS
     Geoffrey M. Rehmet

BUGS
     The control device name should never have been an option, but should have been an optional argument.  Because of this, a single argument is
     treated as a device name.

BSD
								  October 1, 2004							       BSD