Linux and UNIX Man Pages

Linux & Unix Commands - Search Man Pages

wlan_amrr(4) [plan9 man page]

WLAN_AMRR(4)						   BSD Kernel Interfaces Manual 					      WLAN_AMRR(4)

NAME
wlan_amrr -- AMRR rate adaptation algorithm support for 802.11 devices SYNOPSIS
device wlan_amrr DESCRIPTION
The wlan_amrr module implements the Adaptive Multi-Rate Retry tx rate control algorithm for use by 802.11 device drivers. SEE ALSO
bwi(4), iwn(4), ral(4), rum(4), ural(4), wlan(4), wpi(4), zyd(4) STANDARDS
More information can be found in the paper describing the AMRR algorithm at http://hal.inria.fr/inria-00070784/en/. HISTORY
The wlan_amrr driver first appeared in FreeBSD 6.0. BSD
April 13, 2008 BSD

Check Out this Related Man Page

BWI(4)							   BSD Kernel Interfaces Manual 						    BWI(4)

NAME
bwi -- Broadcom BCM43xx IEEE 802.11b/g wireless network driver SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file: device bwi device wlan device wlan_amrr device firmware Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): if_bwi_load="YES" DESCRIPTION
The bwi driver provides support for Broadcom BCM43xx based PCI/CardBus network adapters. It supports station and monitor mode operation. Only one virtual interface may be configured at any time. For more information on configur- ing this device, see ifconfig(8). This driver requires firmware to be loaded before it will work. The ports/net/bwi-firmware-kmod port needs to be installed before ifconfig(8) will work. HARDWARE
The bwi driver supports Broadcom BCM43xx based wireless devices, including: Card Chip Bus Standard Apple Airport Extreme BCM4306 PCI b/g Apple Airport Extreme BCM4318 PCI b/g ASUS WL-138g BCM4318 PCI b/g Buffalo WLI-CB-G54S BCM4318 CardBus b/g Buffalo WLI-PCI-G54S BCM4306 PCI b/g Compaq R4035 onboard BCM4306 PCI b/g Dell Wireless 1470 BCM4318 Mini PCI b/g Dell Truemobile 1400 BCM4309 Mini PCI b/g HP nx6125 BCM4319 PCI b/g Linksys WPC54G Ver 3 BCM4318 CardBus b/g Linksys WPC54GS Ver 2 BCM4318 CardBus b/g TRENDnet TEW-401PCplus BCM4306 CardBus b/g US Robotics 5411 BCM4318 CardBus b/g EXAMPLES
Join an existing BSS network (i.e., connect to an access point): ifconfig wlan create wlandev bwi0 inet 192.168.0.20 netmask 0xffffff00 Join a specific BSS network with network name ``my_net'': ifconfig wlan create wlandev bwi0 ssid my_net up Join a specific BSS network with 64-bit WEP encryption: ifconfig wlan create wlandev bwi0 ssid my_net wepmode on wepkey 0x1234567890 weptxkey 1 up SEE ALSO
arp(4), cardbus(4), intro(4), pci(4), wlan(4), wlan_amrr(4), ifconfig(8), wpa_supplicant(8) HISTORY
The bwi driver first appeared in FreeBSD 8.0. AUTHORS
The bwi driver was written for DragonFly BSD by Sepherosa Ziehau and subsequently ported to FreeBSD. BUGS
Some card based on the BCM4306 and BCM4309 chips do not work properly on channel 1, 2 and 3. BSD
May 16, 2009 BSD
Man Page