netbsd man page for posix_madvise

MADVISE(2)						      BSD System Calls Manual							MADVISE(2)

NAME
     madvise -- give advice about use of memory

LIBRARY
     Standard C Library (libc, -lc)

SYNOPSIS
     #include <sys/mman.h>

     int
     madvise(void *addr, size_t len, int behav);

     int
     posix_madvise(void *addr, size_t len, int advice);

DESCRIPTION
     The madvise() system call allows a process that has knowledge of its memory behavior to describe it to the system.  The posix_madvise()
     interface is identical and is provided for standards conformance.

     The known behaviors are:

     MADV_NORMAL      Tells the system to revert to the default paging behavior.

     MADV_RANDOM      Is a hint that pages will be accessed randomly, and prefetching is likely not advantageous.

     MADV_SEQUENTIAL  Is a hint that pages will be accessed sequentially, from the lower address to higher address.  It might cause the VM system
		      to depress the priority of pages immediately preceding a given page when it is faulted in.

     MADV_WILLNEED    Is a hint that pages will be accessed in the near future.  It might cause the VM system to make pages that are in a given
		      virtual address range to temporarily have higher priority, and if they are in memory, decrease the likelihood of them being
		      freed.  It might immediately map the pages that are already in memory into the process, thereby eliminating unnecessary
		      overhead of going through the entire process of faulting the pages in.  It might or might not fault pages in from backing
		      store.

     MADV_DONTNEED    Is a hint that pages will not be accessed in the near future.  It might allow the VM system to decrease the in-memory prior-
		      ity of pages in the specified range.

     MADV_FREE	      Gives the VM system the freedom to free pages, and tells the system that information in the specified page range is no
		      longer important.

     Portable programs that call the posix_madvise() interface should use the aliases POSIX_MADV_NORMAL, POSIX_MADV_SEQUENTIAL, POSIX_MADV_RANDOM,
     POSIX_MADV_WILLNEED, and POSIX_MADV_DONTNEED rather than the flags described above.

RETURN VALUES
     Upon successful completion, a value of 0 is returned.  Otherwise, a value of -1 is returned and errno is set to indicate the error.

ERRORS
     madvise() will fail if:

     [EINVAL]		Invalid parameters were provided.

SEE ALSO
     mincore(2), mprotect(2), msync(2), munmap(2), posix_fadvise(2)

STANDARDS
     The posix_madvise() system call is expected to conform to the IEEE Std 1003.1-2001 (``POSIX.1'') standard.

HISTORY
     The madvise system call first appeared in 4.4BSD, but until NetBSD 1.5 it did not perform any of the requests on, or change any behavior of
     the address range given.  The posix_madvise() was invented in NetBSD 5.0.

BSD
								  March 29, 2011							       BSD