|Linux & Unix Commands - Search Man Pages
ud - interactive LDAP Directory Server query program
ud [-Dv] [-s server] [-d debug-mask] [-l ldap-debug-mask] [-f file]
ud is used to interogate a directory server via the Lightweight Directory Access Protocol
-s server Used to specify the name of an LDAP server to which ud should connect. If this
flag is omitted, the value specified in the ud configuration file is used. If
no value is specified in the configuration file, or the configuration file does
not exist, the name ldap is used. Of course, it is up to the system administra-
tor to make sure that the name ldap can be resolved (presumably through the use
of a CNAME or A record in the DNS and the appropriate search path specified in
the resolver config file).
Sets the ud debug mask to the value specified. Values for the mask can be
dumped by using the -D flag.
-f file Sets the configuration file to the name specified.
Sets the LDAP debug mask to the value specified.
-v Turns on verbose output. Also toggable via the ud verbose command.
-D Prints out a list of valid ud debug masks.
/etc/openldap/ud.conf The ud configuration file.
ud.conf(5), ldap.conf(5), ldap(3)
ud will try to be nice about error conditions, and in most cases prints a warm and fuzzy
error message when it encounters a problem. Sometimes the error will be unexpected, and
in these cases, ud uses the ldap_perror() routine to print an informative diagnostic.
Too numerous to mention.
Bryan Beecher, University of Michigan
OpenLDAP is developed and maintained by The OpenLDAP Project (http://www.openldap.org/).
OpenLDAP is derived from University of Michigan LDAP 3.3 Release.
4.3 Berkeley Distribution 20 August 2000 UD(1)
All times are GMT -4. The time now is 08:21 AM.