Unix/Linux Go Back    


OpenDarwin 7.2.1 - man page for tail (opendarwin section 1)

Linux & Unix Commands - Search Man Pages
Man Page or Keyword Search:   man
Select Man Page Set:       apropos Keyword Search (sections above)


TAIL(1) 			   BSD General Commands Manual				  TAIL(1)

NAME
     tail -- display the last part of a file

SYNOPSIS
     tail [-F | -f | -r] [-b number | -c number | -n number] [file ...]

DESCRIPTION
     The tail utility displays the contents of file or, by default, its standard input, to the
     standard output.

     The display begins at a byte, line or 512-byte block location in the input.  Numbers having
     a leading plus (``+'') sign are relative to the beginning of the input, for example, ``-c
     +2'' starts the display at the second byte of the input.  Numbers having a leading minus
     (``-'') sign or no explicit sign are relative to the end of the input, for example, ``-n 2''
     displays the last two lines of the input.	The default starting location is ``-n 10'', or
     the last 10 lines of the input.

     The options are as follows:

     -b number
	     The location is number 512-byte blocks.

     -c number
	     The location is number bytes.

     -f      The -f option causes tail to not stop when end of file is reached, but rather to
	     wait for additional data to be appended to the input.  The -f option is ignored if
	     the standard input is a pipe, but not if it is a FIFO.

     -F      The -F option implies the -f option, but tail will also check to see if the file
	     being followed has been renamed or rotated.  The file is closed and reopened when
	     tail detects that the filename being read from has a new inode number.  The -F
	     option is ignored if reading from standard input rather than a file.

     -n number
	     The location is number lines.

     -r      The -r option causes the input to be displayed in reverse order, by line.	Addition-
	     ally, this option changes the meaning of the -b, -c and -n options.  When the -r
	     option is specified, these options specify the number of bytes, lines or 512-byte
	     blocks to display, instead of the bytes, lines or blocks from the beginning or end
	     of the input from which to begin the display.  The default for the -r option is to
	     display all of the input.

     If more than a single file is specified, each file is preceded by a header consisting of the
     string ``==> XXX <=='' where ``XXX'' is the name of the file.

DIAGNOSTICS
     The tail utility exits 0 on success, and >0 if an error occurs.

SEE ALSO
     cat(1), head(1), sed(1)

STANDARDS
     The tail utility is expected to be a superset of the IEEE Std 1003.2-1992 (``POSIX.2'')
     specification.  In particular, the -F, -b and -r options are extensions to that standard.

     The historic command line syntax of tail is supported by this implementation.  The only dif-
     ference between this implementation and historic versions of tail, once the command line
     syntax translation has been done, is that the -b, -c and -n options modify the -r option,
     i.e. ``-r -c 4'' displays the last 4 characters of the last line of the input, while the
     historic tail (using the historic syntax ``-4cr'') would ignore the -c option and display
     the last 4 lines of the input.

HISTORY
     A tail command appeared in PWB UNIX.

BSD					   June 6, 1993 				      BSD
Unix & Linux Commands & Man Pages : ©2000 - 2018 Unix and Linux Forums


All times are GMT -4. The time now is 04:17 PM.