Unix/Linux Go Back    

OpenDarwin 7.2.1 - man page for env (opendarwin section 1)

Linux & Unix Commands - Search Man Pages
Man Page or Keyword Search:   man
Select Man Page Set:       apropos Keyword Search (sections above)

ENV(1)				   BSD General Commands Manual				   ENV(1)

     env -- set and print environment

     env [-i] [name=value ...] [utility [argument ...]]

     env executes utility after modifying the environment as specified on the command line.  The
     option name=value specifies an environmental variable, name, with a value of value.  The
     option '-i' causes env to completely ignore the environment it inherits.

     If no utility is specified, env prints out the names and values of the variables in the
     environment, with one name=value pair per line.

     If the utility is invoked, the exit status of env shall be the exit status of utility; oth-
     erwise, the env utility exits with one of the following values:

     0	     The env utility completed successfully

     1-125   An error occurred in the env utility.

     126     The utility specified by utility was found, but could not be invoked.

     127     The utility specified by utility could not be found.

     The historic - option has been deprecated but is still supported in this implementation.

     execvp(3), environ(7)

     The env utility conforms to IEEE Std 1003.2-1992 (``POSIX.2'').

     env doesn't handle commands with equal (``='') signs in their names, for obvious reasons.

BSD					 August 27, 1993				      BSD
Unix & Linux Commands & Man Pages : ©2000 - 2018 Unix and Linux Forums

All times are GMT -4. The time now is 06:08 PM.