belkin(8) [minix man page]

BELKIN(8)							    NUT Manual								 BELKIN(8)

NAME

       belkin - Driver for Belkin serial UPS equipment

NOTE

       This man page only documents the hardware-specific features of the belkin driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

       The belkin driver is known to support the Regulator Pro 525 (F6C525-SER). Other similar models such as the 425 and 625 should also work.

       The Trust UPS and older Belkin units are not supported.

EXTRA ARGUMENTS

       This driver does not support any extra settings in the ups.conf(5).

BUGS

       There are dragons lurking within the protocol to this UPS. I have one that essentially behaves like a glorified power strip due to some
       invasive probing on my part. Don't mess with it directly.

	   Note
	   the driver doesn't go anywhere near these character sequences, so it won't zap your UPS. I only mention this here as yet another
	   reminder of the perils of closed hardware.

SEE ALSO

   The core driver:
       nutupsdrv(8)

   Internet resources:
       The NUT (Network UPS Tools) home page: http://www.networkupstools.org/

Network UPS Tools						    05/21/2012								 BELKIN(8)

LIEBERT(8)							    NUT Manual								LIEBERT(8)

NAME

       liebert - Driver for Liebert contact-closure UPS equipment

NOTE

       This man page only documents the hardware-specific features of the liebert driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

       This driver supports some Liebert UPS equipment with a contact-closure interface. This includes the UPStation GXT2 with their
       contact-closure cable. The smart mode ("Multilink") cable is not supported by this driver.

EXTRA ARGUMENTS

       This driver does not support any extra settings in the ups.conf(5).

BUGS

       This driver does not yet support shutdowns by raising DTR. Be aware that shutdowns are not possible with the stock contact-closure cable.
       You may have to build another cable with DTR connected through to the UPS for it to work.

       There is no way for this driver to detect the hardware or cable. It will start up successfully even if no UPS is present. This is a
       fundamental limitation of any contact-closure driver.

SEE ALSO

   The core driver:
       nutupsdrv(8)

   Internet resources:
       The NUT (Network UPS Tools) home page: http://www.networkupstools.org/

Network UPS Tools						    05/21/2012								LIEBERT(8)