NANOSLEEP(3P) POSIX Programmer's Manual NANOSLEEP(3P)
This manual page is part of the POSIX Programmer's Manual. The Linux implementation of this interface may differ (consult the correspond-
ing Linux manual page for details of Linux behavior), or the interface may not be implemented on Linux.
nanosleep - high resolution sleep (REALTIME)
int nanosleep(const struct timespec *rqtp, struct timespec *rmtp);
The nanosleep() function shall cause the current thread to be suspended from execution until either the time interval specified by the rqtp
argument has elapsed or a signal is delivered to the calling thread, and its action is to invoke a signal-catching function or to terminate
the process. The suspension time may be longer than requested because the argument value is rounded up to an integer multiple of the sleep
resolution or because of the scheduling of other activity by the system. But, except for the case of being interrupted by a signal, the
suspension time shall not be less than the time specified by rqtp, as measured by the system clock CLOCK_REALTIME.
The use of the nanosleep() function has no effect on the action or blockage of any signal.
If the nanosleep() function returns because the requested time has elapsed, its return value shall be zero.
If the nanosleep() function returns because it has been interrupted by a signal, it shall return a value of -1 and set errno to indicate
the interruption. If the rmtp argument is non-NULL, the timespec structure referenced by it is updated to contain the amount of time
remaining in the interval (the requested time minus the time actually slept). If the rmtp argument is NULL, the remaining time is not
If nanosleep() fails, it shall return a value of -1 and set errno to indicate the error.
The nanosleep() function shall fail if:
EINTR The nanosleep() function was interrupted by a signal.
EINVAL The rqtp argument specified a nanosecond value less than zero or greater than or equal to 1000 million.
The following sections are informative.
It is common to suspend execution of a process for an interval in order to poll the status of a non-interrupting function. A large number
of actual needs can be met with a simple extension to sleep() that provides finer resolution.
In the POSIX.1-1990 standard and SVR4, it is possible to implement such a routine, but the frequency of wakeup is limited by the resolution
of the alarm() and sleep() functions. In 4.3 BSD, it is possible to write such a routine using no static storage and reserving no system
facilities. Although it is possible to write a function with similar functionality to sleep() using the remainder of the timer_*() func-
tions, such a function requires the use of signals and the reservation of some signal number. This volume of IEEE Std 1003.1-2001 requires
that nanosleep() be non-intrusive of the signals function.
The nanosleep() function shall return a value of 0 on success and -1 on failure or if interrupted. This latter case is different from
sleep(). This was done because the remaining time is returned via an argument structure pointer, rmtp, instead of as the return value.
sleep(), the Base Definitions volume of IEEE Std 1003.1-2001, <time.h>
Portions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2003 Edition, Standard for Information Technol-
ogy -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of
Electrical and Electronics Engineers, Inc and The Open Group. In the event of any discrepancy between this version and the original IEEE
and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained
online at http://www.opengroup.org/unix/online.html .
/The Open Group 2003 NANOSLEEP(3P)