hpux man page for ripngd

ripngd(1M)																ripngd(1M)

NAME
       ripngd - RIPng routing daemon for IPv6

SYNOPSIS
       config_file] trace_options] [trace_file]

DESCRIPTION
       is  a  routing  daemon  that  works with Route Administration Manager (RAMD) for IPv6.  This routing daemon is an implementation of Routing
       Information Protocol for IPv6 defined in RFC 2080.  is invoked automatically if it is enabled in the configuration file.

   Options
       supports the following command-line options:

       Parses the configuration file for syntax errors and terminates exits with status 0 if the configuration file contains no error.	In case of
       any error, exits with a non-zero value.	prints the configuration file errors, if any, to the standard output.

       Parses the configuration file for syntax errors and terminates

       Specifies an alternate configuration file to be used by
	      By default, uses the configuration file.

       Specifies that
	      runs as a normal process and not as a daemon process.

       Specifies that
	      does not modify the kernel forwarding table.  That is, will not send route updates to ramd(1M).

       Suppresses stderr messages of
	      This option suppresses informational messages which are normally printed to the standard output, and log error messages through sys-
	      logd(1M).  By default, errors are logged in

       Specifies a comma-separated list of trace options that
	      must be enabled when starting No space is allowed between this option and its arguments.

	      See ramd.conf(4) for information on valid trace options and tracing.

       trace_file
	      Name of the file used by to log tracing information.  If trace options are specified without  specifying	a  trace  file,  uses  the
	      default trace file

Signal Processing
       The following HP-UX signals can be used to control

       Specifies    to reread the configuration file.  reads the configuration file and reconfigures its policies.

       Specifies that the current state of
		    be written to dump file

       Graceful shutdown.
		    On receipt of attempts a graceful shutdown.  removes all protocol route from the kernel routing table upon receiving

       Toggle tracing.
		    If	tracing  is enabled, this signal suspends tracing and closes the trace file.  If tracing is disabled, opens the trace file
		    and initiates tracing.  This is useful for moving trace files.

		    cannot be used if does not enable tracing in the configuration file.

AUTHOR
       was developed by Future Software Ltd.

SEE ALSO
       netstat(1), ifconfig(1M), ram_monitor(1M), ramd(1M), rdc(1M), fork(2), ramd.conf(4).

																	ripngd(1M)