hpux man page for factor

factor(1)						      General Commands Manual							 factor(1)

NAME
       factor, primes - factor a number, generate large primes

SYNOPSIS
       [number]

       [start[stop]]

DESCRIPTION
       If  no arguments are provided on the command line, waits for a number to be typed in.  If a positive number is typed, it factors the number
       and print its prime factors; each one is printed the proper number of times.  It then waits for another number.	exits if it  encounters  a
       zero or any non-numeric character.

       If an argument is provided on the command line, factors the number as above, then exits.

       Maximum time to factor is proportional to sqrt(n) and occurs when n is prime or the square of a prime.

       The largest number that can be dealt with by is 1.0e14.

       prints  prime numbers between a lower and upper bound.  If no arguments are provided on the command line, waits for two numbers to be typed
       in.  The first number is interpreted as the lower bound; the second as the upper bound.	All prime numbers in the resulting inclusive range
       are printed.

       If  start  is  specified, all primes greater than or equal to start are printed.  If both start and stop are given, all primes occurring in
       the inclusive range start through stop are printed.

       start and stop values must be integers represented as long integers.

       If the stop value is omitted in either case, runs either until overflow occurs or until it is stopped by typing the interrupt character.

       The largest number that can be dealt with by is	2,147,483,647.

DIAGNOSTICS
       Both commands print when the input is out of range, illegal characters are encountered, or when start is greater than stop.

EXAMPLES
       Print the prime factorization for the number 12:

       Print all prime numbers between 0 and 20:

																	 factor(1)